Hammond Manufacturing CSG10104 GALV SCR COVER - 10 x 10 x 4

No. The CSG10104 is a Type 1 enclosure with an IP20 rating, which means indoor use only, protected against solid objects but with no protection against water. Keep it out of wet locations, outdoor walls, and washdown areas. For a damp or outdoor location you need a Type 3R, 4 or 4X enclosure instead.

It is a 10 x 10 x 4 inch box, with 10 inch height, 10 inch width and 4 inch depth. The 4 inch depth is what decides whether your gutter work, terminal blocks or a small DIN rail assembly will clear the screw cover, so measure your deepest component plus wire bend radius against that 4 inches before committing.

Yes, both. The galvanized screw cover box is built to UL and CSA standards, under UL file E65324 and CSA certification LR21001. Those file numbers are what an electrical inspector or a spec submittal package will ask for, and the Type 1 rating is the enclosure classification to put on the submittal.

Bare galvanized steel, not painted. That matters two ways: the zinc coating gives you corrosion resistance in dry indoor industrial spaces without a finish coat, and the unpainted galvanized surface gives you metal-to-metal continuity for bonding at the cover screws and conduit entries. If you need a specific color on an exposed wall, you want a painted gray enclosure instead.

It is a screw cover junction box with no knockouts, so you punch or drill your conduit entries where your raceway actually lands. That is why these are used as pull and splice boxes: you set the hole pattern to your job. Use a step bit or knockout punch sized to your connector, and remember any hole you make is your responsibility for maintaining the indoor Type 1 enclosure rating.

The CSG10104 is a screw cover box: the 10 x 10 cover lifts off entirely once the perimeter screws are out. That is the right choice for a splice point, a pull box, or a terminal enclosure you open rarely. If technicians will be in it regularly for troubleshooting or metering, a hinged cover enclosure is easier to live with because the door stays captive while you work.

Yes on both, and it is also USMCA compliant and made in Canada. For public and institutional procurement that combination covers the usual environmental declarations plus trade-agreement sourcing requirements in one part number, CSG10104.

6.5 lbs for the complete box and cover. That is a one-hand hold while you start the first fastener, so a single installer can mount it on unistrut, plywood backing or masonry anchors without help. Mounting hardware is not part of the box itself, so plan your anchors for the surface you are landing it on.