NUVO Lighting 60-7872 Valdora 1-Light Pendant, 10in, Polished Nickel, White Opal Glass

The Valdora 1-light pendant ships with two 6 inch rods and two 12 inch rods plus 12 feet of wire, giving a maximum overall height of 50 inches. The fixture body itself is 11 inches high and 10.38 inches wide, so over an island or a counter you can set it anywhere from fixture-only height up to that 50 inch drop by combining rods. No extra downrods are needed unless you want it lower than 50 inches.

It takes one standard medium (E26) base A19 lamp rated up to 60W, and no bulb is packed with the fixture. Buy lamps separately. Dimming depends entirely on the lamp you install, so if you are putting it on a dimmer, specify a dimmable A19 LED or an incandescent A19.

Yes for those spots. The Valdora pendant is damp location rated and cULus listed, so it is suitable indoors over a sink, in a bath, or in a covered porch ceiling that stays dry of direct water. It is not rated for wet locations, so skip open eaves or anywhere it can be rained on.

The Valdora is a ceiling-mounted rod pendant wired for 120V. Mounting is to a standard ceiling outlet box; the rod-and-canopy design is intended for a flat ceiling. On a slope you would need a canopy or adapter that compensates for the pitch to keep the rod plumb.

At 5.72 lbs the fixture is well under the 50 lb limit a standard listed outlet box supports, so no added bracing or fan-rated box is required. The housing is steel with a polished nickel finish.

NUVO Lighting part number 60-7872, also printed as 60/7872. Polished nickel is the single finish configuration for this model number; the 10 inch white opal glass shade is part of that same part number.

Each shade is 10.38 inches across, so two or three will sit comfortably over most islands with roughly 24 to 30 inches on center between them. Because the kit includes both 6 inch and 12 inch rods and allows up to 50 inches of total height, you can match drop heights across a row without ordering extra parts.

The shade is white opal glass in the Valdora vintage-style profile, polished nickel hardware. Opal glass diffuses the lamp rather than leaving the filament visible, which keeps glare down at eye level over a counter or in a hallway. The fixture is built for incandescent-style A19 lamps, so a frosted or filament A19 both read well behind it.

RoHS compliant, yes. It also carries a California Proposition 65 warning for lead, which is standard on fixtures with brass or plated metal components. For institutional and government procurement that is the disclosure you will need on file.

No. There is no CCT selection on the fixture, and no integrated LED. Color temperature is whatever A19 lamp you put in it, which actually makes it easy to standardize a building at one Kelvin value by buying lamps in bulk.