NUVO Lighting 62-1799 Blink Pro Plus, 19.5W, 12in, CCT Selectable, Brushed Nickel Finish, 120-277V, Square

The 62-1799 carries a damp location rating and is listed for indoor use, so it works in a bathroom ceiling, a covered laundry, or similar damp indoor spot. It is not a wet location fixture, so no direct-spray or exposed exterior locations. Safety listing is cETLus.

Yes. The Blink Pro Plus 62-1799 is a universal-voltage fixture rated 120V/277V, so the same part number works on a 120V residential or light-commercial circuit and on a 277V branch in an office, school, or multi-family corridor. That means one SKU can be standardized across both circuit types in a facility.

No can required. The Blink Pro Plus 62-1799 is a surface mount, close-to-ceiling fixture that mounts flat to the ceiling over a standard junction box. At 1.06 inches deep it sits nearly flush, which is why it gets used in low-ceiling corridors, closets, and stairwells where a pendant or deeper drum would be in the way.

The 62-1799 is dimmable, so it can go on a dimmed circuit rather than switched-only. The light source is an integrated LED, not a lamp in a socket, so there is no bulb to change: the fixture is replaced at end of life. Rated average life is 50,000 hours, which is the number to plan relamping budgets around in high-burn-hour areas.

The 62-1799 is CCT selectable, meaning the color temperature is chosen at the fixture rather than by ordering a specific Kelvin version. Output shifts slightly with the setting, rated 1300 to 1410 lumens across the range at 19.5 watts. CRI is 90, which is high enough for retail display, healthcare, and hospitality spaces where color rendering is specified.

It is a square fixture measuring 12.00 inches by 12 inches with a 1.06 inch height, and it weighs 3 lbs. That weight is light enough for a standard ceiling box with no added bracing, and the 12 inch square footprint is the figure to use when laying out spacing on a corridor or small-room plan.

The base is die-cast aluminum in a brushed nickel finish. Aluminum also helps sink heat off the LED board, which matters in enclosed or high-ambient ceilings. The fixture is an edge-lit LED panel design, so the lit surface is even rather than showing individual diodes.

Brushed nickel is the finish on part number 62-1799. If a project needs a different finish, that is a different NUVO Blink Pro Plus part number, so order by the finish-specific number rather than expecting an option at checkout.

Yes on both counts. The 62-1799 is RoHS compliant, and it carries a California Prop 65 notice for lead. Facilities buyers in California who track Prop 65 disclosures on submittals should record the lead listing.