NUVO Lighting 62-1789 Blink Pro Plus, 19.5W, 12in, Surface Mount LED, CCT Selectable, 90 CRI, Black Finish, 120/277V, Square Shape

Yes. The Blink Pro Plus 62-1789 is a 120V/277V dual-voltage fixture, so the same part number goes on either a 120V branch circuit in a residential or light commercial space or a 277V circuit in a commercial building. No separate voltage version to order.

It is rated for damp locations and listed for indoor use, so a bathroom ceiling or an enclosed, covered area is fine. It is not a wet-location fixture, so keep it out of anywhere exposed to direct water or weather. Mounting is ceiling surface mount.

None. The 62-1789 is a surface mount edge-lit panel that sits on the ceiling face, measuring 12.00 inches long by 12 inches wide with a height of only 1.06 inches. There is no housing to recess and no can required, which is why these get used on concrete decks and finished ceilings where you cannot cut in a can. Fixture weight is 3 lbs.

Yes, the 62-1789 is CCT selectable, so you set the color temperature at the fixture during install rather than ordering a specific Kelvin version. That is what makes it practical for a property manager standardizing on one stocked part across corridors, units, and back-of-house where the existing color temperature varies. It also carries a 90 CRI rating for accurate color rendering.

The fixture is dimmable. It is an integrated LED, not a lamp holder, so dimming performance depends on pairing it with a dimmer rated for LED loads rather than a legacy incandescent dimmer.

No. The light source is an integrated LED, so there is no socket and no lamp to change. Average rated life is 50,000 hours, and at end of life the whole fixture gets swapped. For MRO planning that means you stock the fixture, not lamps.

Output runs 1300 to 1370 lumens at 19.5 watts, with the range reflecting the selected color temperature setting. That lands it in general ambient service for small rooms, closets, corridors, baths, and stairwells rather than as a task or high-bay light.

It carries a cETLus safety listing, which covers both US and Canadian requirements, and it is RoHS compliant. Note the California Prop 65 disclosure for lead.

The base is die-cast aluminum in a black finish, which is the heat-sink path for the LEDs as well as the structure. Die-cast aluminum holds its shape and sheds heat better than a stamped steel pan with a plastic diffuser frame, which is why it is specified for commercial indoor use.

Black only, in the 12 inch square shape. If you need a different trim color on the same fixture family, that is a different NUVO part number, not an option on 62-1789.