NUVO Lighting 65-576 LED Emergency Backlit Flat Panel, 50W, 2ft x 4ft, Selectable CCT, 100-277V

Yes. The 65-576 measures 47.72 inches long by 23.75 inches wide, which drops into a nominal 2 ft x 4 ft grid opening. Plan for depth though: the housing is 3.06 inches tall, so you need that much clear plenum above the grid. It is a ceiling-mount fixture and weighs 12.13 lbs, so support it per your grid and seismic requirements.

It is built as an LED emergency backlit flat panel, so the emergency function is integral to the fixture rather than a separate add-on driver you order. In a corridor or stairwell where you would otherwise hang a separate egress head, this lets one 2x4 panel serve both the normal lighting layer and the emergency layer. Confirm your required egress footcandle levels against your local code before you set fixture spacing.

The panel is CCT selectable, so the color temperature is chosen at the fixture with a switch instead of being locked in at order time. For a property manager or MRO buyer that means one SKU covers offices, corridors and back-of-house, and you can field-match a replacement to the panels already installed around it instead of stocking three color versions. Color rendering is 80+ CRI.

Yes, it accepts 100V to 277V, so the same panel works on 120V in a small tenant space and on 277V on a commercial lighting branch circuit. No separate voltage version to specify. Wire leads are 3.54 inches, so plan your junction box location close to the fixture whip.

No. The 65-576 is rated indoor only, with a damp location rating. Damp covers places like a bathroom or a covered interior area that sees humidity, but not wet locations with direct water exposure or weather. For a garage, canopy or exterior soffit you need a wet-location-rated fixture instead.

The fixture is listed as dimmable. Verify the control protocol against the manufacturer's installation sheet before you commit a floor's worth of panels to an existing control system, since dimmer and driver mismatches are the usual cause of flicker and drop-out at the low end.

It carries a cETLus safety listing, which covers both US and Canadian requirements, and it is RoHS compliant. Note the California Prop 65 content listing for lead if you are supplying a project in California.

There is no lamp to change. The LEDs are integrated into the fixture, so when the array or driver fails you replace the panel, not a bulb. Rated life is 50,000 hours, which at roughly 12 hours a day of operation is around 11 years of service. Housing is aluminum and steel.

White is the finish offered. For a lay-in grid that matches standard white tile grid runs without a custom trim.