NUVO Lighting 65-845-4 LED Area Light Type IV, 200W, Bronze Finish, 5000K, 120-277V

It ships with a 2-3/8 inch slip-fitter mount, so it slides onto a standard 2-3/8 inch OD tenon or horizontal pole arm and clamps down. Nothing else is included for mounting, so if your pole has a square drill-pattern arm plate instead of a round tenon you'll need a different fixture or an adapter. The housing is die-cast aluminum and the fixture weighs 8.42 lbs, light enough for a single-person pole-top install.

Type IV throws a wide forward pattern out from the fixture with little light behind it, which is what you want on a building wall pack-style pole at the edge of a lot, along a property line, or over a loading area where you don't want spill onto a neighbor. If you're lighting from poles in the middle of a lot and need light on both sides of the pole, a Type III or Type V distribution is the better choice. The 65-845-4 is a Type IV only.

One fixture covers the whole range: the driver accepts 120V through 277V, so 120, 208, 240 and 277 all work without ordering a different model. That makes it straightforward to standardize across sites with different service voltages. It's dimmable, so you can tie it to a control system if you're doing scheduled or occupancy-based reduction.

It delivers 26,536 lumens at 200W, which is in the range typically used to replace a 400W to 750W metal halide area light depending on how degraded the existing fixture is. Color is 5000K, a cool white that reads as bright and neutral on asphalt, with 80 CRI. Rated life is 50,000 hours on the integrated LED board.

Yes, it carries a Wet location rating and is listed for outdoor use, so direct rain and snow exposure on an open pole top is fine. Safety listing is cULus Certified, which covers both US and Canadian installs.

No. This is a fixed 5000K fixture, not a field-selectable CCT model. If your site standard is 4000K or 3000K you need a different fixture or a selectable-CCT area light. Worth settling before you order if you're adding to an existing lot and want the new heads to match.

The manufacturer part number is 65-845-4, also written 65/845/4 on NUVO documentation. Bronze is the finish on that number, and it's the only finish this model is built in.

No lamps to buy. The LED array is integrated into the fixture, so there's no socket, no bulb base, and nothing to relamp. When the board or driver reaches end of life the fixture is replaced rather than re-lamped, which is the tradeoff against the 50,000 hour rated life.

Yes, lead is listed as a California Prop 65 chemical for this fixture, so a Prop 65 notice applies on California projects. The fixture is also RoHS compliant.