NUVO Lighting 65-847 LED Area Light Type III, 240W, Bronze Finish, 5000K, 120-277V

The 65-847 ships with a 2-3/8 inch slip-fitter mount, so it slides over a standard 2-3/8 inch OD tenon or horizontal arm and clamps down. If your pole has a drilled-arm pattern instead of a tenon, you need an adapter arm or a tenon adapter, since no arm bracket comes with the fixture. Fixture weight is 11.93 lbs, which is light enough that most existing poles rated for a HID shoebox will take it without a load recheck.

At 32,585 lumens delivered, the 65-847 sits in the range normally covered by a 750W to 1000W metal halide shoebox, so it is a one-for-one swap on tall parking lot and lot-perimeter poles while cutting connected load to 240W. Because it is an integrated LED fixture, there is no ballast or lamp to maintain, and it is rated for 50,000 hours average life.

Type III throws light forward and out to the sides in an asymmetric pattern, which is what you want for poles set along the edge of a lot, a driveway, or a roadway shoulder, where the pole line is off to one side and the light needs to reach across the pavement. For poles in the middle of a lot with parking on both sides, a Type V (square/round symmetric) fixture covers better; for a wall-mount or property-line application where light must not spill past the boundary, a Type IV forward-throw is the closer match. The 65-847 is the Type III version.

Yes. The 65-847 has a universal 120V-277V input driver, so it works on 120, 208, 240 or 277 volt single-phase circuits without changing the fixture or setting a tap. That makes it a straight fit for commercial and multi-family sites running 277V lighting panels. It will not run on 480V.

The fixture is dimmable, so it can be driven by a 0-10V control system for scheduling, occupancy step-dimming, or bi-level after-hours operation. Dimming controls, photocells and any receptacle adapter are ordered separately; the fixture ships with the slip-fitter mount only.

Wet location rated and cULus certified, so it can be pole-mounted in the open where it takes direct rain and snow. The housing is die-cast aluminum, which is the standard body for outdoor area lights because it sheds heat from the LED boards and holds up to weather. Finish is bronze.

It is a fixed 5000K fixture, not field selectable, so it lands at a cool white that matches existing 5000K LED or metal halide lots. If the rest of your site is 4000K, this one will read noticeably bluer next to it. CRI is 80, which is normal for site and security lighting.

The head measures 30.28 inches long, 12.39 inches wide and 3.11 inches high. The shallow 3.11 inch profile matters on windy sites and on older poles, since it presents far less sail area than the HID shoebox it usually replaces.

Yes. Lead is listed as the Prop 65 chemical for this fixture, so shipments into California carry the warning. The fixture is RoHS compliant.