NUVO Lighting TH352 1-Light, MR16, 120V Track Head, Gimbal Ring, Russet Bronze Finish

The TH352 takes a single MR16 lamp with a GU10 bi-pin base, running on line voltage at 120V and rated to 50W. No lamp ships with the head, so order the GU10 MR16 separately. Because it's GU10, there's no transformer involved, which is the usual mix-up with MR16 heads that use a GU5.3 low voltage base.

No. The TH352 is rated for dry locations only and listed for indoor use, so it's out for exterior soffits, covered walkways, parking garages, and wet or damp interior spots like shower areas or unconditioned coolers. For those openings you need a damp or wet location rated head instead.

Two things aren't in the box. You need the lamps, one 120V GU10 MR16 per head, since the TH352 ships without them and holds a single socket. And you need the track and feed, because this is a head only, not a kit. Mounting is ceiling, so the track section, connectors, and power feed have to be on the order too.

Extension is 5.13 inches, with the head measuring 2.13 inches in width and 2.13 inches in height, and it weighs 0.98 lbs. That projection matters in a retail aisle or a corridor with a low ceiling where a head hanging five inches into the clear space gets hit. The sub-pound weight means the run itself is no load problem on a standard track.

Dimming on the TH352 is lamp dependent, meaning the head itself puts no driver or electronics in the path, it just feeds 120V straight to the GU10 socket. A line voltage halogen GU10 will dim on a standard incandescent dimmer. If you lamp it with an LED GU10, dimming performance is entirely a function of that lamp and matching it to the dimmer.

It aims. The gimbal ring holds the MR16 lamp in a pivoting yoke, so you can tilt the beam off vertical to wash artwork, a merchandise wall, or a reception sign rather than just dropping light on the floor below. Aiming is done at the head, so the track run layout doesn't have to sit directly over what you're lighting.

The TH352 carries a cETLus safety listing, which covers it for both US and Canadian installations. It's a ceiling mounted indoor track head, dry location only, and it's RoHS compliant. Note that it carries a California Prop 65 lead warning, which matters if you're shipping into California facilities that require the disclosure.

There's no CCT selectable switch on the TH352, and there's no color temperature built into the head at all. It's a halogen technology head with an open GU10 socket, so the color temperature, beam spread, and lumen output are whatever GU10 MR16 lamp you drop into it. That's how you standardize color across a floor, buy one lamp spec for every head.

Russet Bronze is the only finish the TH352 is built in, so if you're extending an existing run you need the rest of the heads and the track itself to already be a bronze family finish or the mismatch will show. Construction is glass and metal, and the styling is transitional, which sits fine in hospitality and multi-family common areas.

Satco publishes both for the TH352. The spec sheet is at media.satco.com/specsheets/pdf/TH352.pdf and the installation instructions at assets.satco.com under the TH352 product folder. Worth pulling the spec sheet before a submittal, since it's the document a spec reviewer will want attached.