Metallics M14600 Pull Rope 3-Strand Polypropylene 1/4" 600ft

The M14600 is a 1/4 inch diameter polypropylene pull rope supplied in a 600 foot length, in a 3-strand twisted construction.

A 1/4 inch 3-strand polypropylene rope like the M14600 is the general purpose choice for conduit pulls where you want a round, knottable line you can tie off to a pulling eye or basket grip. Flat pull tape is the alternative when you need to keep friction and bulk down in a long or tightly packed raceway. The round twisted rope holds knots and splices better and is easier to hand-pull.

Yes. Polypropylene does not rot or mildew and is unaffected by water, so a 1/4 inch poly rope such as the M14600 is commonly left in place as a drag line for future pulls. The 600 foot put-up gives you enough to leave sections in multiple runs.

Neither. The M14600 is a textile rope, 1/4 inch 3-strand twisted polypropylene, 600 feet to the coil. It is used as a pulling line or drag line, not as a stiff pushing tool. If you need something rigid enough to push through an empty conduit to establish the first path, that is a fish tape or fiberglass rod job; the rope follows behind it.

Each M14600 order is one 600 foot put-up of 1/4 inch 3-strand poly rope. Figure the length of your longest single run plus enough slack at both ends to tie off and hand-pull, then decide how many runs you want roped at once. Crews that leave a drag line in every riser go through a coil fast, so ordering by run count rather than by job is the usual approach.