ROFU 1006 Full Wave Bridge Rectifier with 6” Leads

The ROFU 1006 is a full wave bridge rectifier, so it converts an AC supply into DC. It is the part you add when the transformer or power source on the door feeds AC but the device on the door, such as a DC-only electric strike, maglock, or door holder, has to have DC. Full wave means both halves of the AC waveform are used rather than half of them, which is why it is the usual choice over a single diode when you need steadier DC at the lock.

Yes, that is exactly the situation the 1006 covers. Feeding AC into a DC-only strike or maglock either buzzes loudly or damages the coil. Wiring a full wave bridge rectifier between the AC output and the device gives you the DC the device expects. Match the rectifier's rating to the voltage and current of the circuit you are putting it in before you wire it up.

Leads are already attached. The 1006 ships with 6 inch pigtail leads, so it goes into the box or the raceway and splices straight to your existing AC feed and lock wiring with nuts or crimps. No soldering to bare tabs.

Six inches is pigtail length, meant for landing the rectifier inside a junction box, a power supply enclosure, or a transformer can right next to the connection point. If the rectifier has to sit any distance from the AC source or the strike, plan on splicing on extra conductor of the same gauge and keeping the joints inside an enclosure.

It is a commercial-duty access control accessory, sold as part of ROFU's electronic access control line rather than as a residential part. That is the context it belongs in: electric strikes, magnetic locks, and door holders on commercial openings where the power source is AC and the hardware is DC.

No options to specify. The 1006 is a single model, ordered as ROFU1006, with the 6 inch leads already fitted. There is no finish, length, or voltage variant to pick.