SATCO Lighting S11234 5W, JCD LED, Clear, 3000K, G9 Base, 120V

Yes. The S11234 is a 5 watt G9 LED rated as a 40W incandescent equivalent, putting out 550 lumens on 120 volts. It uses the standard G9 double loop base, so it drops into the same socket a 40W halogen G9 capsule came out of. Light color is 3000K warm white with a clear lens, so it reads close to a halogen in tone.

Yes. The Satco S11234 is an enclosed rated lamp, so it can go in sealed or fully enclosed fixtures without voiding the lamp's rating. It also carries a universal burning position, meaning base up, base down or horizontal are all fine, which matters in sconces and pendant clusters where sockets point every direction.

A bathroom vanity is fine. The S11234 carries a damp location rating and is listed for indoor use, so humidity from a shower is within what it is built for. A covered exterior porch is not covered by that indoor designation, and anything exposed to direct rain needs a wet rated lamp instead.

Each lamp pulls 0.042 amps at 120 volts, so the load per bulb is negligible compared to the halogens they replace. For fleet retrofits in a hotel or multi-family common area, the practical limit becomes the fixture and the dimmer, not the branch circuit. Rated life is 25,000 hours, which is the number that drives the relamp interval.

Yes, the S11234 is Title 24 compliant and FCC compliant. That matters on California residential and hospitality projects where the inspector is checking lamp compliance at the fixture. It is not DLC listed, so it will not qualify for rebate programs that require DLC.

Close. The lamp is a clear T4 shape with a clear plastic lens and a 300 degree beam spread, so it throws light nearly all the way around like a halogen capsule rather than firing in one direction. Color is 3000K warm white at 80 CRI. Where it differs from halogen is the plastic lens versus glass and the LED emitter pattern, which is visible in a fully exposed socket at close range.

Ceramic. The S11234 uses a ceramic base with the G9 double loop pin configuration, which holds up better to socket heat than a molded plastic base in tight enclosed fixtures.

The S11234 is a single configuration: clear finish, 3000K warm white. It is not a CCT selectable lamp, so you cannot switch it to 2700K or 4000K at the bulb. If a job needs a different color temperature across a building, standardize on the matching Satco G9 part for that CCT rather than mixing.

No. The S11234 is not a three-way lamp. In a three-way socket it will run at a single output level rather than stepping, so use it only in standard on/off or dimmed circuits.