SATCO Lighting S11424 14W A19 LED, 4000K, Dimmable, Medium Base, 230 degree Beam Angle, 4-Pack

It is an enclosed rated lamp, so it can go in a closed globe, flush mount, or similar sealed fixture without voiding the rating. Burning position is universal, so base up, base down, or horizontal all work. The housing is a high heat conductive plastic over polycarbonate, which is what lets it shed heat inside a trapped-air fixture.

The lamp is dimmable on 120V, 60Hz line voltage. One thing to watch: older incandescent dimmers were sized for the full 100W load this bulb replaces, and a 14W LED pulling 0.117A may fall below the dimmer's minimum load, which shows up as flicker or a dead band at the bottom of the range. If you are dimming a single bulb on an old rotary dimmer, plan on an LED-rated dimmer instead.

Bathroom and laundry are fine. The lamp carries a damp location rating, which covers spaces with humidity and condensation but no direct water. It is classified as an indoor lamp, so an exposed porch fixture that takes blowing rain needs a wet location rated lamp instead.

No. This 14W A19 is flagged Non-Compliant for California, so it should not be specified for California installations. For those jobs you need a California-compliant A19 LED, typically a JA8-listed lamp.

4000K is a neutral, slightly cool white. It reads clean and task-oriented, which is why it tends to get spec'd for corridors, stairwells, laundry rooms, garages, and back of house. For unit living rooms and bedrooms where tenants expect a warm incandescent look, 3000K or 2700K is the usual choice. This lamp is fixed at 4000K, not field selectable, so you cannot change it at install.

Beam spread is 230 degrees, so it throws light back past the base as well as forward, close to the omnidirectional spread of the incandescent it replaces. The frosted polycarbonate lens diffuses the output, so you do not get the hot spots or visible diodes you see with a clear lamp. That combination suits open shades, table lamps, and bare-socket fixtures where the bulb is in view.

No, it is not a three-way lamp. Put it in a three-way socket and you will get a single light level rather than the low, medium, high steps, and depending on the socket it may only come on in certain switch positions. For a three-way table lamp, order an A19 LED specifically built as three-way.

Average rated life is 15,000 hours. On a common area fixture burning roughly 12 hours a day, that is a bit over three years before the group relamp comes due. It ships as a 4-pack under part number S11424, which is the ordering unit to plan quantities around.

CRI is 80, which is the standard commercial baseline. It is fine for corridors, offices, storage, back of house, and general apartment use. If the spec calls for color-critical work, retail merchandising, exam rooms, or anywhere skin tone and material color matter, look for a 90+ CRI lamp instead.

No. The S11424 is not DLC approved, so it will not qualify under a program that requires a DLC listing. It is FCC compliant for electromagnetic interference, which matters where lamps sit near sensitive electronics or radio equipment.