SATCO Lighting S11425 14W A19 LED, 5000K, Dimmable, Medium Base, 230 degree Beam Angle, 4-Pack

Yes, it is an enclosed rated lamp, so a closed glass dome or a jelly jar is fine. It is also damp location rated, which covers a covered porch, a bathroom over a shower, or a laundry room. It is specified for indoor use, so do not put it in a fixture exposed directly to rain.

No. Satco flags the S11425 as non-compliant for California, so it should not be specified for work in that state. For a California job, pick an A19 LED that carries a California Title 20 compliant designation instead.

The S11425 is dimmable on 120V, 60Hz line voltage. It is not a three-way lamp, so it will not step through low/medium/high in a three-way socket, and it is not CCT selectable, meaning the color stays at 5000K through the whole dimming range.

5000K reads as daylight white, which most tenants find cold in a bedroom or living room. It suits garages, basements, laundry rooms, utility areas, parking corridors, and task lighting where you want crisp light. For unit interiors in multi-family, a 2700K or 3000K A19 is the usual choice. CRI here is 80, which is standard for general-purpose lighting but short of what you would want for color-critical retail display.

230 degrees is a wide omnidirectional spread, so light goes out and up as well as down. That makes the S11425 right for table lamps, open shades, bare-socket ceiling fixtures, and wall sconces where you want the shade and ceiling to pick up light. If you need a controlled downward beam, such as in a recessed can for aisle lighting, a BR or PAR reflector lamp is the better type. The frosted polycarbonate lens diffuses the LEDs so you do not see hot spots through a clear shade.

Average rated life is 15,000 hours. Each lamp pulls 0.117A at 120V, so a long run of fixtures on one 15A or 20A branch circuit uses very little of it compared with the 100W incandescent lamps they replace. Useful when you are re-lamping corridors or a parking structure and want to keep the existing circuiting.

No. The S11425 is not DLC approved, so it will not qualify under rebate programs that require a DesignLights Consortium listing. It is FCC compliant for electromagnetic interference.

Any orientation works. Burning position is universal on the S11425, so base up, base down, or horizontal are all acceptable. The housing is high heat conductive plastic over a polycarbonate body rather than glass, which helps in fully enclosed base-up fixtures where heat collects.

S11425 is sold as a 4-pack of the 14W 5000K A19 LED in the frost finish. Handy for re-lamping a four-light vanity or a small set of fixtures in one go without breaking a case.