SATCO Lighting S11619R1 12W LED Direct Wire Downlight, Gimbaled, 4 Inch, CCT Selectable, Round, Remote Driver, 850 Lumens, 120V

The S11619R1 is a direct wire recessed downlight, so it goes in without a can. Its trim measures 5.04 inches in diameter with a 2.00 inch height, which covers a nominal 4 inch ceiling cutout. Because the driver is remote rather than packed behind the trim, the housing depth needed in the ceiling cavity is just the 2 inch body plus room to route the driver leads.

Yes. The S11619R1 carries a Wet location rating and is listed for both indoor and outdoor use, so showers, covered porches and exterior soffits are all in scope. It is cETLus Listed and FCC compliant.

Five field-selectable settings: 2700K, 3000K, 3500K, 4000K and 5000K. Set each fixture at install to match the warmth of the existing lamps, so one part number covers warm residential corridors and cooler 4000K/5000K back-of-house areas. Wattage is fixed at 12W, 850 lumens, with no wattage switch.

Yes, the S11619R1 is California T24 Listed, which matters on CA residential and multi-family work where recessed luminaires must be on the approved list. It is also RoHS compliant.

The LED driver is a separate component wired away from the trim instead of sitting in the plenum behind it. That lets the fixture body stay shallow (2 inches tall) for tight ceiling cavities and puts the driver somewhere serviceable, but it also means you need accessible space for the driver and must follow the Satco wiring instructions for lead routing on a 120V, 60Hz circuit.

Dimming is supported on the S11619R1, running on a 120V 60Hz supply. Since the driver is remote, the dimmer must be compatible with that driver, so check the dimmer compatibility note on the Satco instruction sheet before specifying your control.

The trim is gimbaled, so the LED module tilts within the 5.04 inch round housing to aim light off axis. That is what you want for wall washing, art, or to keep the beam vertical on a sloped or vaulted ceiling. A fixed round trim cannot do either.

The light source is integrated, so there is no lamp to change. Rated life is 50,000 hours, and when it ends the trim itself is replaced. For MRO buyers standardizing a building, that argues for keeping a spare or two of the same part number on the shelf.

Aluminum construction with a black finish, which is the only finish offered on the S11619R1. The fixture weighs 1.11 lb, light enough for spring-clip retention in drywall or a shallow plenum.