SATCO Lighting S11620R1 12W LED Direct Wire Downlight, Gimbaled, 4 Inch, CCT Selectable, Round, Remote Driver, 850 Lumens

The S11620R1 is a 4 inch gimbaled downlight with a trim diameter of 5.04 inches and a body height of 2.00 inches, so the trim covers a nominal 4 inch cut opening and you need about 2 inches of plenum depth above the ceiling for the fixture itself. It mounts recessed direct wire, meaning it goes into the opening without a can and connects straight to line voltage.

It's a remote driver design, so the LED driver is a separate module tied to the fixture by a lead rather than being built into the housing. You need to plan space for that driver in the plenum and keep it accessible per your local inspector. The fixture runs on 120 volts at 60 Hz.

Yes. The S11620R1 carries a Wet location rating and is listed for both indoor and outdoor use, which covers showers, covered porches and exterior soffits. It's cETLus Listed.

Color is field selectable at the fixture across five settings: 2700K, 3000K, 3500K, 4000K and 5000K. That lets a property manager stock one part number and match warm 2700K in residential units and 4000K or 5000K in back of house or garage areas. The switch position is set before install; see the Satco instruction sheet for its location.

Output is fixed. The S11620R1 draws 12 watts and delivers 850 lumens, with no wattage selection switch, only color temperature selection. If you need a field adjustable lumen package, this isn't the fixture.

It's dimmable and the driver ships with the fixture as a remote module, so no separate driver purchase is needed. Use a 120V dimmer rated for LED loads and confirm the total connected wattage on the circuit against the dimmer's LED rating.

No lamp to buy. The LED array is integrated into the fixture and rated for 50,000 hours average life, so there is no relamping cycle, the whole unit is replaced at end of life. That's the trade off MRO buyers weigh against a socketed can with a replaceable retrofit lamp.

The gimbal lets you aim the light after install, which is what you want over artwork, a sloped ceiling, or washing a wall. A fixed trim throws straight down and is the better pick for even general ceiling coverage. The S11620R1 is the gimbaled round version at 4 inch, 850 lumens.

The S11620R1 is California T24 Listed, which matters if you are permitting recessed lighting in California residential or commercial work. It is also FCC compliant and RoHS compliant.

Brushed Nickel is the finish offered on this model, on an aluminum base. If you are matching a run of existing white trims across a building, this one will not blend in.