SATCO Lighting S11626R1 12W LED Direct Wire Downlight, Gimbaled, 3.5 Inch, CCT Selectable, Round, Remote Driver, 840 Lumens

Yes. The S11626R1 carries a Wet location rating and is listed for both indoor and outdoor use, which covers showers, exterior soffits, and covered entries. It is cETLus Listed.

Five CCT settings are selectable on the fixture: 2700K, 3000K, 3500K, 4000K and 5000K. For a property manager matching a corridor or unit that is already 3000K warm white or 4000K neutral, you set each fixture to that value instead of stocking separate SKUs. Wattage is fixed at 12W and is not selectable, with 840 lumens output. The setting procedure is covered in the Satco installation instructions.

Yes, the trim is gimbaled, so the LED module tilts within the 4.38 inch round housing to aim light off axis. That is what makes it workable on a sloped ceiling or for accenting a wall, versus a fixed downlight that only shoots straight down. Finish is brushed nickel.

Dimmable, yes, driven at 120 volts. It is also listed as California T24 compliant, which matters if you are specifying for residential or commercial work in California where Title 24 lighting requirements apply. Confirm the dimmer you are pairing is rated for LED loads.

The LED is integrated, so there is no replaceable lamp. Average rated life is 50,000 hours. At that rating the whole fixture is the serviceable unit, which is the tradeoff MRO and multi-family buyers accept for the shallow remote driver form factor.

Aluminum body, 0.98 pound per fixture. Aluminum helps pull heat off the LED, which matters in insulated or tight ceiling cavities, and the sub-pound weight keeps the load on the ceiling trivial when you are installing many of them.

Both, yes. It is RoHS compliant and FCC compliant, cETLus Listed, and manufactured in Vietnam. Those are the items that usually come up on government, healthcare, and education submittal packages.

840 lumens from 12 watts suits general ceiling spacing in corridors, baths, kitchens, and closets where a 3.5 inch aperture is specified. For high ceilings or a single fixture covering a large room, you would step up to a larger aperture or add fixtures rather than expect more from this one, since wattage here is fixed and not selectable.

Brushed nickel is the only finish offered on the S11626R1. If a job calls for white or black trim throughout, you would be specifying a different Satco part number rather than an option on this one.