SATCO Lighting S11628R1 12W LED Direct Wire Downlight, Gimbaled, 3.5 Inch, CCT Selectable, Square, Remote Driver, 840 Lumens, 120V

It is a recessed direct wire fixture on 120 volts, 60 Hz, so the branch circuit lands on the fixture leads. The driver is remote, meaning the driver module sits outside the trim and must be located in an accessible spot above the ceiling and connected to the light head. Plan for that driver location before cutting the hole.

Yes. The fixture carries a Wet location rating and is listed for both indoor and outdoor use, so showers, exterior soffits, and covered entries are all in scope. It is cETLus Listed and FCC compliant, and the housing is aluminum.

Yes, it is CCT selectable across five settings: 2700K, 3000K, 3500K, 4000K and 5000K. For a property manager replacing a few heads in a run of existing fixtures, you set the switch to 3000K and it blends with the rest of the openings, and the same part number covers warmer retail-style 2700K or cooler 4000K office areas without stocking multiple SKUs.

Wattage is fixed at 12W, 840 lumens; there is no wattage selector on this model. Color temperature is the only field-selectable setting. The fixture is dimmable, so output is controlled at the dimmer rather than at the fixture.

The gimbal lets you aim the beam after install, so it is the choice for sloped ceilings, wall washing artwork or signage, and accenting millwork. A fixed downlight only throws straight down. This one is also square rather than round, which lines up with square trims and grid or panel layouts; if the ceiling already has round trims, a square aperture will read as a mismatch.

The S11628R1 is California T24 Listed, so it can be specified on projects in California subject to Title 24 lighting requirements. It is also RoHS compliant and cETLus Listed.

No. The LED is integrated, so there is no replaceable lamp or socket. It is rated 50,000 average hours, and at end of life the fixture head is swapped rather than relamped. Facilities standardizing on relampable trims should look at a fixture with an actual lamp base instead.

Black only, on an aluminum body. There is no white or bronze option under this part number, so for a white ceiling where the trim needs to disappear this is the wrong choice.

1.01 lb per fixture. Light enough to hang off the trim clips in drywall without supplemental bracing in a typical ceiling, which matters when you are installing a few dozen on a remodel.