SATCO Lighting S11630 12W LED Direct Wire Downlight, 3.5in, 3000K, 120V, Dimmable, Round, Remote Driver, White

The S11630 is a 3.5 inch round downlight with a 4.38 inch outside diameter trim and a 3 inch overall height, so it covers a 3.5 inch rough opening and needs about 3 inches of clearance above the ceiling plane. It mounts to the ceiling and installs with spring clips, so it can go into an existing 3.5 inch housing or into a can-less opening of that size.

The driver is a separate component located away from the light module rather than built into the housing, which is what keeps the fixture body shallow at 3 inches. It is a direct wire unit running on 120V at 60Hz, so it connects to line voltage branch wiring in a junction box instead of screwing into a lamp socket. Plan on space to place and access the driver above the ceiling.

It carries a wet location rating, so it is suitable for showers and other damp or wet interior spots. It is designated an indoor fixture, so a covered exterior soffit is outside what it is rated for; pick a fixture listed for outdoor use there.

It is listed as California T24 compliant, and it is cETLus Listed as well. For a multi-family or residential project in California that needs T24 compliant recessed luminaires, this one qualifies on that basis.

No. It is fixed at 3000K warm white, with no CCT selector and no wattage selector. If you are standardizing a building on a single color, that works in your favor, but you cannot field adjust it to 2700K or 4000K, so order the temperature you want.

Yes, the S11630 is dimmable on a 120V circuit. The LED module is integrated, so dimming is handled by the remote driver and the wall control, not by changing lamps. Verify the dimmer you are using is rated for LED loads and size it to the total connected wattage of the fixtures on the circuit.

The LED is integrated, with no lamp base or socket, so there is no bulb to change. It is rated for 50,000 average hours; at end of life the fixture module gets replaced. For MRO stocking, that means carrying the fixture, not lamps.

Aluminum body, 1.09 lb per fixture. The aluminum acts as the heat sink for the LED, which matters in insulated ceilings, and the light weight means the spring clips alone hold it in a drywall ceiling opening.

White only, in a round utility trim profile. If you are matching other openings in a building that use black or brushed nickel trims, this one will not blend in.

Both. The S11630 is RoHS compliant and FCC compliant, cETLus Listed, and made in China. That set covers the usual compliance line items on a government or healthcare submittal for a recessed LED luminaire.