SATCO Lighting S11770 6W A19 LED, Medium Base, CCT Selectable, White Finish, 90 CRI, 120V

Yes, the S11770 is an enclosed rated lamp, so a closed globe, a jelly jar, or a flush drum fixture is fine. It also carries a damp location rating, which covers covered exterior entries, laundry rooms, and bathrooms, and it will burn in any position, base up, base down, or horizontal. It is an indoor lamp, so do not put it anywhere exposed to direct rain or standing water.

The S11770 is field selectable between 3000K, 4000K, and 5000K, so one bulb covers warm white through daylight. That is the main reason to stock it across a mixed portfolio: you buy one SKU and match whatever is already in the corridor, the unit, or the office. 3000K reads warm and residential, 4000K is the usual neutral for common areas and back of house, 5000K is a cool daylight often used in utility and work spaces.

No. The S11770 is not dimmable, and it is not a three-way lamp either. Put it on a dimmed circuit and you will get flicker, buzz, or no start at all, and on a three-way socket it will only run at one level. For dimmed fixtures or three-way table lamps, order a dimmable A19 LED instead. This one belongs on plain switched circuits, which is most corridor, closet, stairwell, and back of house lighting.

The S11770 is a 90 CRI lamp, which is the threshold most hospitality and healthcare specs call for. At 90 CRI, paint colors, wood tone, skin tone, and fabric read correctly, where a typical 80 CRI bulb flattens reds and makes finishes look muddy. If you are lighting guest rooms, leasing units, exam areas, or anywhere a color decision gets made, the 90 CRI is the reason to pick this over a commodity bulb. For a back of house stairwell it matters much less.

No. The S11770 is not DLC listed, so it will not clear a utility program that requires DesignLights Consortium qualification for the incentive. If a rebate is funding the retrofit, check the program's list before committing to this lamp. It is FCC compliant and lawful for sale in California, so nothing blocks you from installing it, the rebate paperwork is the only issue.

The beam spread is 220 degrees with a frosted lens, so light goes out sideways and forward the way an incandescent A19 does, not in a narrow cone. That is what you want in a table lamp, a wall sconce, or an open shade where the bulb has to light the room rather than a spot on the floor. The frost also keeps the diodes from showing as hot points in a clear or open fixture.

Plastic base, white housing. Plastic bases do not corrode or weld themselves into a socket the way an aluminum base can in a damp fixture, so removal at relamp is usually easier. Handle it by the base rather than twisting on the bulb body, same as any LED lamp.