SATCO Lighting S11826 10W, LED Direct Wire Downlight, Edge-lit, 4in, CCT Selectable, 120V, Dimmable, Round, Remote Driver

Five CCTs are selectable on the fixture itself: 2700K, 3000K, 3500K, 4000K and 5000K. That is the practical reason to spec it across a building, one part number covers warm residential-feeling 2700K units in units and corridors and 4000K or 5000K in back-of-house, so you stock one SKU instead of five. Output is 700 lumens at 10 watts. Wattage is not selectable, only color temperature.

Treat the S11826 as a dry/indoor interior fixture. It is rated IP20 and listed for indoor locations, which means it is protected against finger contact but not against water ingress. Bathroom ceilings outside the shower zone are a normal application, but do not put it in a shower, a covered exterior soffit, or any damp or wet location. For those openings you need a downlight specifically marked damp or wet rated.

Yes, the S11826 is listed as Title 24 compliant, which is what matters if you are specifying recessed downlights into a California job. It is also cETLus listed for US and Canadian use, FCC compliant, and RoHS compliant.

Usually yes. Because the S11826 is a direct wire head with a remote driver, you pull the old trim and lamp, connect the driver leads to the existing branch wiring inside the can or to a J-box, and push the driver up into the cavity. The 4.72 inch trim diameter covers a 4 inch aperture, and the 0.90 inch body sits nearly flush. Where the existing can is sealed or there is no room beside it for the driver box, you will need to open the ceiling to place the driver.

The S11826 is dimmable on 120V, 60Hz line voltage through its remote driver. It is an integrated LED, so there is no lamp to swap and no separate dimming lead, the dimming happens on the incoming hot. Pair it with a forward or reverse phase dimmer rated for LED loads, and check the Satco installation instructions for the compatible dimmer list before you commit a whole floor.