SATCO Lighting S11863 15W, CCT Selectable, LED Direct Wire Downlight, Gimbaled, 6in Square, Remote Driver, Black

Direct wire, no can needed. It is a direct wire downlight with an integrated LED and an external remote driver, so the driver sits separately above the ceiling and the trim itself clips into the opening. Run it on 120V, 60Hz. Because the driver is remote rather than built into the trim, you need accessible space above the ceiling to place and connect it.

The S11863 has a field selectable CCT switch with five settings: 2700K, 3000K, 3500K, 4000K and 5000K. You pick the color at install, so one part number covers warm residential-style 2700K through neutral 4000K office work and 5000K utility spaces. Wattage is fixed at 15W and is not selectable, so output does not change with the color setting.

Bathroom ceiling, yes. Exterior soffit, no. The S11863 is rated for damp locations and indoor use only, with an IP42 rating, which covers dust and dripping conditions but not wet locations or direct water exposure. For a covered porch or soffit you need a wet location rated fixture instead.

That is the practical case for the S11863. One SKU covers five color temperatures, so a property manager can stock a single part and set 2700K in units, 3500K or 4000K in corridors and common areas. Output lands between 1280 and 1400 lumens at 15 watts depending on the setting, and the gimbal lets you aim light at walls or artwork on the same trim used for general lighting. Finish is black.

A gimbal lets you tilt the light module after install, so you can wash a wall, hit retail displays or correct for a sloped ceiling without changing the housing. The S11863 is the gimbaled square version at 15 watts and 1280 to 1400 lumens. If all you need is even general illumination straight down, a fixed round trim is simpler and cheaper to aim-free install.

No. The LED is integrated with no replaceable lamp or socket, rated 50,000 average hours. When it fails you swap the trim, not a bulb. The remote driver is a separate component, so a driver failure can be addressed without pulling the trim out of the ceiling.

Aluminum, both for the trim body and the base. It weighs 1.06 lb, light enough for spring clip retention in drywall or a tile ceiling without added support. The aluminum body also serves as the heat sink for the integrated LED.