SATCO Lighting S21300 4W CA10 LED, Frost, Candelabra Base, 90 CRI, 2700K, 120V

Both are allowed. The S21300 is an enclosed rated lamp, so it can go in a sealed globe or lantern without voiding its rating, and it carries a wet location rating for indoor or outdoor use. That covers exterior post lanterns, covered entry fixtures and enclosed sconces, which is where most non-enclosed-rated LED candles fail early.

It is dimmable on a 120V line-voltage dimmer. It is not a three-way lamp, so in a three-way socket it will light at a single output rather than stepping through levels. For three-way table lamps you need a lamp specifically listed as three-way.

Yes, the S21300 is listed as Title 24 compliant, which is what a California project spec usually asks for on screw-base lamps. It is also FCC compliant. It is not a DLC listed product, so it will not qualify for utility rebate programs that require DLC listing.

Burning position is universal, so base-up, base-down or horizontal are all fine. That matters on chandeliers and sconces where sockets are angled or inverted. The lamp uses an LED filament with a glass envelope and nickel plated aluminum base, and the frost finish diffuses the filament so it is not a hard point of glare in an open shade.

Average rated life is 15,000 hours, and the beam spread is 300 degrees, so it throws light nearly all the way around the lamp rather than in one direction. For property managers that combination is the point: an omnidirectional candle lamp in a chandelier or wall sconce lights the room evenly and cuts relamping trips compared with a 40W incandescent.

If the fixture lights a space where finishes, food, or skin tone matter, yes. The S21300 renders at 90 CRI, well above the 80 CRI typical of commodity LED candles, so wood, fabric and paint colors read truer under it. At 2700K and 350 lumens it suits hotel lobbies, restaurant dining rooms and residential entry chandeliers where the bulb is visible and the light quality is part of the look.

Frost is the finish offered under part number S21300, and the lamp is fixed at 2700K. It is not a CCT selectable product, so if a job calls for 3000K or 4000K candelabra lamps you need a different Satco part number rather than a field setting on this one.