SATCO Lighting S39029 9W LED Direct Wire Downlight, 5-6in, 5000K, 120V, Dimmable

Title 24 compliant, which is the box a California job needs checked on recessed ceiling fixtures. It's also cETLus Listed for use in the US and Canada, FCC compliant, and RoHS compliant, which covers the paperwork most institutional and government specs ask for.

It dims. The fixture runs on 120V at 60Hz line voltage, so it works on a standard forward or reverse phase wall dimmer, and an LED-rated dimmer is what you want, since a legacy incandescent dimmer sized for a 65W load is often above the minimum load an integrated 9W LED can hold and will flicker or drop out at the low end. Wattage is fixed at 9W, so there's no output tap to set on install.

There is no bulb. It's an integrated LED, so the diodes, driver, and trim are one sealed assembly and the fixture is the replacement unit. Rated life is 40,000 hours, which is the number to plan a relamp cycle against across a portfolio. If your maintenance staff needs a screw-in lamp they can swap from a ladder, this is not the right choice, look at a retrofit that keeps a medium base socket in the can.

Overall height is 2.81 inches, with the fixture measuring H:2.81" DIA:6.69". Part of that height sits below the ceiling as trim, so plan the plenum depth against 2.81 inches total. Mounting is ceiling only, and it's a recessed downlight, not a surface or suspended fixture.

White is the only finish. It's a round trim, 6.69 inches across, in a utility style, so it reads as a plain flat downlight rather than a decorative or baffle trim. Housing is thermal conductive plastic and aluminum, which is what carries the heat off the LED in a closed ceiling cavity.

Satco publishes both for this model. Installation instructions are at https://assets.satco.com/dj18eqo18/image/upload/v1713463030/products/S39029/S39029_Instructions.pdf and the full spec sheet is at https://media.satco.com/specsheets/pdf/S39029.pdf. Order by MPN S39029 so the submittal matches what ships.