SATCO Lighting S9664 9.5W, A19 LED, Frosted, 5000K, European Medium base (E27), 220 degree Beam Angle, 230V, Non-Dimmable

No, it is non-dimmable. Put it on a dimmer circuit and you will get flicker, buzz, or premature failure. It is also not a three-way lamp, so it will only operate at full output on a three-way socket. Use it on plain on/off switching.

It carries a damp location rating, so covered porches, bathrooms and similar humid but protected spots are fine. Damp is not wet, so do not use it where it will take direct rain or hose spray. Burning position is universal, so base up, base down or horizontal all work.

It replaces a 60 watt incandescent, putting out 900 lumens on 9.5 watts. Current draw is 0.041A, so a circuit that once carried a handful of 60W lamps has a lot of headroom if you relamp with these across a building.

5000K is daylight white, a crisp blue-white. It suits back of house, laundry, parking garages, workshops and utility spaces where you want visibility. For resident-facing rooms, corridors and hospitality guest areas most property managers go warmer. The color temperature is fixed on this lamp, not selectable, so what you order is what you get across the whole fleet.

No, the S9664 is not DLC approved, so it will not qualify for rebate programs that require a DesignLights Consortium listing. It is FCC compliant. If your project is being funded off a utility incentive, pick a DLC listed lamp.

Frosted lens with a 220 degree beam spread, so light goes out and back past the bulb rather than forward in a cone. That is what you want in a table lamp, a ceiling drum, or an open shade where a directional bulb would leave the top of the fixture dark. The frost also softens the LED source so you are not looking at bright points through a clear glass.

Plastic base with a white housing. Plastic-based lamps will not seize or corrode into a socket the way brass-skirted lamps sometimes do, which matters if you are relamping fixtures on a cycle. Handle by the body, not the base, when you install.