Schlage Commercial 61-503 Combination Screw Pack, 2x B600-078 & 4x C603-897, For Use With B562P Conventional Cylinder & Over 1-3/4" To 2-1/4" Thick Doors

Yes. The 61-503 combination screw pack is specified for doors over 1-3/4 inches up to 2-1/4 inches thick, so a 2 inch door sits inside that range. It is the screw kit that goes with a Schlage B562P conventional cylinder when the door is thicker than standard.

No. The 61-503 screw pack starts above 1-3/4 inches and runs to 2-1/4 inches. At exactly 1-3/4, the standard commercial door thickness, your door is below the range this pack is built for, so it is the wrong part. Measure the leaf before ordering, because the whole reason this pack exists is doors that fall above that standard.

Six screws in one pack: two B600-078 and four C603-897. That combination is what the 61-503 covers, so you order the one part number rather than sourcing the two screw types separately. It is an installation accessory for a B562P conventional cylinder, not a lock or cylinder itself.

The 61-503 is matched to the B562P conventional cylinder and that is the lock it is sized for. Screw lengths on a thick-door kit are cut to a specific lock, so if you are working on a different Schlage model, order the thick-door screw pack listed against that model instead of substituting this one.

Three finishes are available on the 61-503: 626 satin chrome, 613 oil rubbed bronze, and 605 bright brass. Order the one that matches the B562P it is going into, since exposed screw heads on the interior plate will read against the lock finish if they do not match.

Commercial. The 61-503 screw pack sits in Schlage's commercial line and pairs with the B562P conventional cylinder, which is the side of the catalog a property manager or MRO buyer standardizing across a building would be working from. For a facility with a mix of door thicknesses, this is the pack you keep on the shelf for the leaves that run over 1-3/4 inches.