Metallics JSS2414SS Screw 10-24 x 1/4 SKT S-Scr Cup 18-8 (Jar 100)

Yes. The JSS2414SS is 18-8 stainless, the common 300 series austenitic grade used where corrosion resistance matters, such as damp or outdoor electrical enclosures and wet locations.

A cup point bites into the mating surface with a ring-shaped edge, which gives good holding on a shaft or bus without the deep penetration of a cone point or the full-contact bearing of a flat point. It is the general purpose choice for locking a collar, lug, or connector body in place, and the one you use when you do not mind a small witness mark on the part underneath. The JSS2414SS is a cup point in 10-24 x 1/4.

It is a socket set screw, so it drives with a hex key (Allen wrench) in the internal socket, not a screwdriver. The head is flush or recessed into the tapped hole when seated, so there is nothing protruding to catch.

At 1/4 inch of overall length, this screw only engages the first portion of a deep hole and will sit below the surface once driven in. That is fine for a shallow boss or a thin-wall fitting where 1/4 inch is the full depth, but for a deeper lug or collar you need a longer 10-24 set screw so the point reaches the shaft. Measure the hole depth plus the clamped thickness before choosing the length.

100 screws per jar, and the pack type is a jar rather than a box or bag. That quantity suits an MRO crib or a service van where you are replacing lost set screws across a lot of fittings rather than buying for one job.