Metallics JTHS1 Screw 6 x 1 Trm SD FT S-Pt DWS Blk-P (Jar 100)

The JTHS1 is a #6 by 1 inch screw, packed 100 to a jar. The jar pack is the standard put-up for this item, so order by jar rather than by individual piece.

It is a drywall screw (DWS in the Metallics description), #6 by 1 inch, with a sharp point and full thread. The sharp point starts in gypsum board and light framing without pre-drilling, and the full thread runs the whole shank for holding power over a short 1 inch length.

Black phosphate coated. That finish is for dry interior work such as board and trim fastening; it offers no meaningful corrosion protection, so for exterior or damp locations choose a coated or stainless fastener instead.

The JTHS1 uses a trim head, which is smaller in diameter than a standard bugle head, so it countersinks neatly and leaves a small hole to fill. That smaller bearing surface is the point of it on trim and moulding, but it also means less pull-through resistance in soft board than a bugle head, so use it where the head needs to disappear rather than where the screw has to clamp paper-faced gypsum alone.

Order Metallics JTHS1. That is the manufacturer part number for the #6 x 1 inch trim head, full thread, sharp point drywall screw in black phosphate, jarred 100 pieces.