Klein Tools 33732INS Screwdriver Set, Slim-Tip Insulated Phillips and Cabinet Tips, 2-Piece

Yes. Both drivers in the 33732INS set are insulated and rated to 1000 volts, and they meet or exceed ASTM F-1505-16 and IEC 60900:2018, the two standards an electrical inspector or safety program will ask about. The orange insulation layer is impact and flame resistant. Klein's own warning still applies: de-energize whenever you can, and never touch the uninsulated portion of the tool when it might contact an energized source.

Two drivers: a #2 Phillips and a 1/4-inch cabinet tip (slotted with a parallel, non-flared blade). Both are on 4-inch round shanks, so they handle panel screws and terminal screws in the same depth of work.

That is what the slim-tip design is for. On the 33732INS the insulation runs flush to the tip rather than stopping short with a bulge, so the shank stays close to the bare diameter and reaches down into recessed breaker and terminal screws a standard insulated driver cannot enter. The flush insulation also reduces nicking when you work it in and out. Shank length is 4 inches, so it is a short-reach driver, not a long-reach panel driver.

No, the 33732INS tips are not magnetized. If you want a magnetic tip to hold a cover screw in place, this is not the set, and magnetizing an insulated driver yourself is not something to do to a 1000-volt tool. For insulated work, plan on starting screws by hand.

A cabinet tip has parallel sides rather than a flared blade, so the 1/4-inch tip enters a 1/4-inch slot in a recessed or counterbored hole without the shoulder catching on the surrounding metal. That is why it is the usual choice for terminal screws inside panels and device boxes. A flared keystone blade of the same width will not drop into the same hole.

Both handles carry Klein's Tip-Ident marking on the butt of the handle, which shows the tip type and its orientation. Handy when you are reaching into a panel and want to line the blade up with the screw before you can see the tip.

Steel shanks with a black rubber Cushion-Grip handle over them, and the orange insulation layer is impact and flame resistant. Keep them clean, dry and free of surface contaminants, and inspect the insulation before every use on energized work, since a nick or a gouge is what takes an insulated tool out of service.

Order it as Klein Tools 33732INS. It is a sealed 2-piece set (one #2 Phillips, one 1/4-inch cabinet tip) rather than individually ordered drivers, with a combined weight of 0.47 lbs.