You may also like
WAC Lighting Patriot 5CCT 3" Square Downlight Remodel
Model: WAC-R3HSDR-F9CS
Patriot 3 inch Downlight and Adjustable RecessedPatriot 5CCT 3" RND Downlight RemodelFeaturesDelivered Lumens: Up to 1035lmCBCP: 30952700K/3000K/3500K/4000K/5000KCRI: 90Power: 12WInput: 120-277 VAC,...
WAC Lighting
$134.00
$117.95
Ion 2 inch Square Remodel Downlight
Minimum profile downlight with metal conduit and driver included for easy
remodel or new construction installation.
Features
- Delivered Lumens: 755lm
- CBCP: 1014
- 3000K
- CRI: 90
- Power: 9W
- Input: 120-277 VAC, 50/60Hz
- IC Rated, Airtight
- ELV Dimming: 100-10%
- TRIAC Dimming: 100-5%
- Rated Life: 50000 Hours
- Construction: Die-cast Aluminum with 20-gauge Cold Rolled Steel Driver Box
- Sold as remodel, but new construction frame available
- Metal Conduit with Quick Connect to allow for easy installation
- Driver included
Manufacturer Resources:
Manufacturer Resources
Product Specs
- Product Group:
- Indoor Lighting
- Product Subgroup:
- Accessories
- Brand Family:
- WAC Limited
- Subcategory:
- Ceiling Lighting
- Segment:
- Lighting
- Product Category:
- Lighting Accessories
- Department:
- Electrical
WAC Lighting R2DSDR-F930-WT – Frequently Asked Questions
1) Can the WAC Ion 2 inch square downlight be installed in an existing ceiling without opening the drywall?
Yes. The Ion 2 inch square downlight ships as a remodel (retrofit) unit, with the driver and a metal conduit with quick connect already included, so it goes in through the ceiling cutout and feeds back to the driver box above the drywall. If you are roughing in new work and would rather set a housing before the ceiling goes up, a new construction frame is offered for the same fixture.
2) Is the WAC Ion 2 inch downlight safe to install against insulation in an attic?
It is IC Rated and airtight, so it can be in direct contact with insulation and it limits air leakage between the conditioned space and the attic. That matters on top-floor units and anywhere you are chasing an envelope spec.
3) Will this 2 inch WAC downlight work on a 277V commercial circuit?
Yes. The Ion 2 inch square remodel downlight accepts 120-277 VAC at 50/60Hz, so the same part number works on residential 120V and on 277V lighting branch circuits in commercial buildings. No separate voltage version to specify.
4) What dimmer type do I need for the WAC Ion 2 inch square downlight, and how low will it go?
It dims on either ELV or TRIAC (forward phase) controls. On ELV the range is 100 to 10 percent; on TRIAC it goes down to 5 percent. If you want the deeper dim for a bedroom or hospitality application, spec a TRIAC dimmer. There is no 0-10V option on this fixture.
5) Do I need to order a driver or transformer separately for the WAC Ion 2 inch downlight?
No. The driver comes with the fixture, housed in its own steel driver box and connected by metal conduit with a quick connect fitting. You wire line voltage to the driver box and plug the light module in. Nothing else to buy to make it light, though you do need a compatible ELV or TRIAC dimmer if the circuit is dimmed.
6) Is a 2 inch 755 lumen downlight bright enough for general ceiling lighting?
The Ion 2 inch square delivers 755 lumens at 9W, with a center beam candlepower of 1014. That output is in the range used for general downlighting in residential and hospitality ceilings, and the high CBCP relative to the lumen package means it is a tighter, more directional beam, so it also works for accenting. For wide ambient coverage over a large room you will want tighter spacing than you would use with a 4 inch fixture.
7) What color temperature and color rendering does the WAC Ion 2 inch square downlight produce?
Fixed 3000K warm white with a CRI of 90. It is not field-selectable, so if you are matching existing downlights in a building, confirm the other fixtures are 3000K before you mix them in the same ceiling. The 90 CRI puts it where designers and hospitality specs usually want it for finish and skin tones.
8) Is the WAC Ion 2 inch square remodel downlight durable enough for a rental or multi-family ceiling?
Construction is die-cast aluminum with a 20-gauge cold rolled steel driver box, and the LED is rated for 50,000 hours of life. The aluminum body helps sink heat off the LED, which is what gets you that life in an insulated ceiling. The LED and driver are integral, so there is no lamp for a tenant to change or take with them.
9) Does the WAC Ion 2 inch downlight come in a round trim instead of square?
The Ion 2 inch remodel downlight, part number R2DSDR-F930-WT, is the square aperture in a white finish. WAC builds the Ion family in a round version as well, so if your ceiling layout calls for round apertures, order the round Ion remodel rather than this one. The square and round are not interchangeable trims on the same body.
How fast can I get the WAC Lighting R2DSDR-F930-WT delivered?
Most orders ship the same day from our distribution partners, with quick delivery throughout the
continental
U.S.
Need it urgently? Contact Us for expedited shipping options.
Can I return it if it doesn’t work for me?
Yes—ZenSupply offers a hassle-free return policy. If the product isn’t the right fit,
reach out to our support team for a return authorization or setup a return by following our return instructions.
Does the WAC Lighting R2DSDR-F930-WT come with a warranty?
Absolutely. The WAC Lighting R2DSDR-F930-WT is backed by a manufacturer’s warranty.
For full warranty terms, check the product documentation or Contact Us.
How do I get technical support or installation help for the WAC Lighting R2DSDR-F930-WT?
You can call, text, or email our expert support team for fast answers. We’re here to help with
product
selection,
installation tips, and troubleshooting. Contact Us
Why buy the WAC Lighting R2DSDR-F930-WT from ZenSupply?
ZenSupply makes it easy to get the commercial door hardware you need—fast shipping, expert support,
and
rewards on
every order.
Our team is always ready to help you choose the right product for your project.