Thomas & Betts WMG-PC16 1-1/4IN WIREMESH GRIP SST 1.375-1.5

The WMG-PC16 is sized for cable in the 1.375 to 1.5 inch outside diameter range, paired with a 1-1/4 inch trade size fitting. Mesh grips only hold properly when the cable OD falls inside the stated band, so measure the jacket before ordering. Cable smaller than 1.375 inches will slip through the weave instead of gripping.

Stainless steel. That matters if the grip is going into a wet, washdown, coastal, or corrosive process area where a plated or galvanized mesh would rust out at the weave. For dry indoor runs either material works, but stainless is the one that holds up outdoors and in food or chemical plants.

A mesh grip like the WMG-PC16 wraps the cable jacket and tightens under load, taking the strain off the termination so the conductors are not carrying the weight of a vertical drop or supporting a run at a box entry. Electricians use them at cord and cable entries and on vertical risers. It is a support and strain relief device, not a conduit fitting by itself.

Order it as Thomas & Betts WMG-PC16. That single part number covers the 1-1/4 inch size in stainless with the 1.375 to 1.5 inch cable range. Distributors stocking a range of mesh grips should note the size band is what separates it from the adjacent WMG part numbers, not the finish.