Ty-Duct TYD1X2NPG6 1X2 NARROW SLOT GRAY DUCT, 100 Pack

Each length of the TYD1X2NPG6 narrow slot duct runs 6 ft (1.83 m). It is sold by the foot as the unit of measure, and this is the 100 pack configuration, so plan your cut list in 6 ft sticks rather than assuming a continuous run.

No adhesive backing on the TYD1X2NPG6. It mounts mechanically, so budget for screws or rivets and a drilled base when you lay out the panel or backboard. Fasteners are not part of the duct.

The TYD1X2NPG6 measures 1 in (25.4 mm) net width, so it needs a 1 inch clear footprint plus a little room either side for the finger flex when you snap the cover on. If your DIN rail spacing is tighter than that, step down to a smaller cross section rather than forcing this one in.

Narrow slot refers to the entrance type: the fingers along the sidewall leave narrow openings, which hold small-gauge control and instrumentation wire in place as you lay it in. That is what you want on a control panel where conductors break out frequently and you do not want them spilling out before the cover goes on. For heavy bundles or large-diameter power cable, a wider slot entrance is easier to load. The TYD1X2NPG6 is the narrow slot version.

It is PVC in grey, which is the standard color for panel wiring duct, so it will sit alongside existing gray runs without looking like a patch. PVC also means you can cut it with a fine-tooth saw or duct cutter on site.

That is what it is for. It is plastic wiring duct, used to route and dress conductors inside enclosures, on backboards, and along panel interiors. The narrow slot entrance suits small control and signal conductors. It is a wire management channel, not a raceway substitute, so it does not replace conduit or EMT where code requires an enclosed raceway.

Yes. The TYD1X2NPG6 wiring duct has a country of origin of the United States, which is what institutional and government buyers working under domestic-preference purchasing rules usually need documented.