B-Line 30.5 mm, Heavy-Duty Joystick Operator

Yes. The Eaton/B-Line 10250T heavy-duty joystick operator, model 10250T45112, mounts in a 30.5 mm panel opening, which is the standard hole used across the 10250T heavy-duty pushbutton line. If your enclosure or control station is already punched for 30.5 mm oiltight devices, this drops into that prep.

The 10250T45112 joystick carries NEMA 3, 3R, 4, 4X, 12 and 13 ratings, so it is suited to outdoor rain and sleet exposure, hosedown and washdown areas, corrosive duty (4X), and dust or oil laden industrial interiors. The enclosure it goes into has to carry the same rating for the assembly to hold it.

It is a four-position joystick, with the positions given as UP, DOWN and RIGHT plus center. If your control scheme needs travel in all four compass directions, this is not the operator for that application.

This part is the operator only, the joystick mechanism and mounting that goes through the 30.5 mm panel hole. Contact blocks are the separate half of a 10250T assembly and are selected by the number of circuits and the contact arrangement your control scheme needs, so plan on ordering them alongside the operator.

No. Model 10250T45112 is built without overcurrent latch. If your panel design relies on a latching overcurrent feature in the operator itself, you need a different 10250T joystick variant and should handle the protection in the circuit instead.

A joystick like the 10250T45112 puts multiple directional commands under one hand and one 30.5 mm hole, which is what you want for jogging a hoist, conveyor diverter or positioner where the operator is watching the load, not the panel. Separate momentary pushbuttons make more sense when commands are unrelated, need individual legend plates, or have to be spread apart to prevent accidental actuation. Note this operator gives three named directions, UP, DOWN and RIGHT, so a true X-Y application needs a different device.

Yes, that is the point of staying in the series. The 10250T heavy-duty line shares the 30.5 mm mounting and the same contact block system, so a joystick can sit in the same control station as 10250T buttons and selectors and use common spare parts. Keeping to one series is the simplest way to standardize spares across a plant.

Order it as 10250T45112. That is the manufacturer part number for the 30.5 mm heavy-duty four-position joystick operator without overcurrent latch, and it is the only configuration offered under it.