Altronix AL1002ULADA NAC Power...
IN STOCK (leaves warehouse same day if ordered before 3pm ET)
$896.65
$700.95
Altronix AL1002ULADA NAC Power Extender, Input 120VAC 60 Hz, 5A, Class 2 Rated Power Limited Outputs

Altronix AL1002ULADA NAC Power Extender, Input 120VAC 60 Hz, 5A, Class 2 Rated Power Limited Outputs

(No reviews yet) Write a Review

Model: AL1002ULADA

In Stock (leaves warehouse same day if ordered before 3pm ET)

$896.65
$700.95
Adding to cart… The item has been added
Free Shipping on orders over $199
We price match and offer bulk discounts! Click Add to Quote. It's quick and easy.
✨
Earn points with this purchase! You can redeem points for giftcards, iPads, XBox's and more. View Rewards
Free Keying on all locks
You may also like

Power Supply/Charger, Input 115VAC 60Hz at 3.5A, 8 Fused Outputs, 12/24VDC at 6A, Grey Enclosure

AL600ULPD8 is a multi-output power supply/charger that converts a 115VAC, 60Hz input into eight (8) 12VDC or 24VDC non power-limited outputs.

Ideal for a multitude of purposes, including CCTV, Fire Alarm and POIP.

 

A leading global provider of power and transmission technologies for professional security system applications, Altronix develops innovative solutions that integrate disparate infrastructure and maximize overall performance and efficiency.

 

Altronix Power Supplies are ideal for a multitude of purposes, including:

  • General Use
  • CCTV
  • Fire Alarm
  • POIP

Manufacturer Resources

Product Specs

Warranty:
Lifetime
Subcategory:
Access Power Controller With Power Supplies
Commercial/Residential:
Commercial
Product Group:
Electronic Access Controls
Product Subgroup:
Power Supplies
Product Type:
Power Supplies
Product Voltage:
120V
Product Category:
Electronic Access Controls
Department:
Door Hardware

Altronix AL1002ULADA – Frequently Asked Questions

1) Does the Altronix AL1002ULADA run off standard building power, or does it need a low-voltage feed?
The AL1002ULADA is wired to standard 120V AC building power at 60 Hz, so it lands on a dedicated branch circuit like any other panel-mounted supply. There is no low-voltage input to it; it is the device that creates the DC for the notification and access devices downstream.
2) What is a NAC power extender actually for, and do I need one on my job?
A NAC (notification appliance circuit) power extender is used when the fire alarm control panel can't carry the current for all the horns, strobes, and other notification devices on a circuit. The extender takes building power and supplies the appliance circuits itself, following the panel's trigger, so the panel's own NAC output only has to signal rather than power the load. If your panel's NAC capacity is short on a floor or wing, that is the case for the Altronix AL1002ULADA. If you only need DC for door hardware and access control, a straight access control supply is the simpler buy.
3) I need power for maglocks and electric strikes, not fire notification. Is the Altronix AL1002ULADA the right unit?
No. The AL1002ULADA is built as a fire alarm notification circuit extender, not as an access control supply. For maglocks, strikes, and electrified exit hardware you want a 12/24VDC access control supply instead. The Von Duprin PS902 is a 2A 12/24VDC field-selectable base unit for access control, the RCI DKPS-2A gives you eight 12/24VDC outputs at 2A, and if you need more headroom the SDC 634 Series is a 4 amp regulated and filtered low voltage supply.
4) I need battery backup at the door. Which supplies include it?
The Adams Rite PS-1 is a regulated 1 amp 12/24 volt DC supply with battery backup, the Command Access PS204/204B provides 2A at 24VDC with battery backup, and the Detex 10-800 Series universal logic controller ships with a 120VAC/24VDC power supply and battery backup. If standby power is a requirement of your fire or egress design, specify one of those rather than assuming it from the Altronix AL1002ULADA, which is described as a NAC power extender with a 120VAC 60 Hz input.
5) What is a comparable 12/24VDC power supply if I need more than 5 amps of output?
The Altronix AL1002ULADA is rated 5A with Class 2 rated power limited outputs. If the load calculation comes in higher, the BEST PS161-6 is a 120V input, 12/24V output supply with 6A capacity, and the Securitron AQS1210 is a switching supply rated 12 VDC at 10 amps. The AQS1210 is single voltage at 12 VDC, so confirm your devices are 12V before substituting it for a dual-voltage unit.
6) What should I use instead if the exit devices are motorized latch retraction?
Motorized latch retraction devices draw a high inrush current and are normally powered by a supply built for them. The BEST RPSMLR2 Series is a power supply for motorized latch retraction exit devices, and for delayed egress hardware the BEST PS161-6 is a 120V input, 12/24V output supply with 6A capacity. Match the supply to the exit device manufacturer's requirement rather than substituting a general 5A unit like the Altronix AL1002ULADA.
7) My exit devices use motorized latch retraction. Will an Altronix NAC extender power them?
No, and this is a common mix-up. Motorized latch retraction draws a heavy inrush and needs a supply built for that duty cycle, such as the BEST RPSMLR2 Series, which is made specifically for motorized latch retraction exit devices. A notification circuit extender like the AL1002ULADA is not intended for that load.
8) I only need to power one or two electric strikes. Is there a smaller alternative to the AL1002ULADA?
Yes. For a small single-opening job the Command Access PS1 is a 24VDC linear supply with 1 amp output, the SDC 620 Series is a 1 amp regulated and filtered low voltage supply with dual voltage selection, and the Securitron AQD1 is a 12/24 VDC switching supply at 1 amp. Step up slightly and the SDC 631 Series gives 1.5 amps and the SDC 632 Series gives 2 amps, both with dual voltage selection. The AL1002ULADA is a 5A unit, so those smaller supplies are the closer match when the connected load is a single device.
9) I need multiple fused outputs to feed several doors from one cabinet. What else offers that?
The RCI DKPS-2A provides 8 outputs at 12/24VDC rated 2A for access control systems, which is the multi-output approach at a lower total current. The Locknetics LP Series is offered as a 150 and 250 amp power supply with enclosure for larger distributed installations. The Altronix AL1002ULADA is a 5A unit with Class 2 rated power limited outputs, so compare total current against the sum of your door loads, not just the output count.
10) Is there a field-selectable 12/24V access control supply in the 2 to 4 amp range as an alternative?
Yes. The Von Duprin PS902 is a Grade 1 base power supply rated 2A, field selectable between 12 and 24 VDC for access control. The Securitron AQL4 is a switching supply at 12/24VDC rated 4A and 3A respectively, and the SDC 634 Series is a 4 amp regulated and filtered low voltage supply with dual voltage selection. All three sit below the Altronix AL1002ULADA's 5A rating, so size against your measured load.
11) My 24VDC lock is at the end of a long wire run and dropping voltage. Is there a supply that compensates?
The Command Access PS210 is a UL 6E/CSA linear power supply with 1.5A at 24VDC output and boost circuitry, which is the feature aimed at long-run voltage drop. It is a 1.5A unit, so it fits a single or small group of devices rather than replacing a 5A supply like the Altronix AL1002ULADA.
12) Is the Altronix AL1002ULADA a residential product or is it meant for commercial buildings?
It is a commercial-duty unit, catalogued for commercial installation and intended for fire alarm and life safety work in occupied buildings rather than house wiring. Expect it to be installed in an enclosure on a dedicated circuit by a licensed installer.
13) Is the Altronix AL1002ULADA sold in more than one configuration?
It is a single model, AL1002ULADA. There are no finish, voltage, or output variations to select, so ordering is just the one part number.
14) What is a simpler plug-in option for one 12VDC device with a time delay?
The ROFU 9126T is a plug-in mini power supply rated 12 VDC at 1.5A with time delay, and the ROFU 9102-12D UL/9102-24D takes a 10/120VAC 60Hz input for a boxed installation. Those suit a single opening; the Altronix AL1002ULADA is a 5A unit with Class 2 rated power limited outputs and is sized for larger circuits.
How fast can I get the Altronix AL1002ULADA delivered?
Most orders ship the same day from our distribution partners, with quick delivery throughout the continental U.S. Need it urgently? Contact Us for expedited shipping options.
Can I return it if it doesn’t work for me?
Yes—ZenSupply offers a hassle-free return policy. If the product isn’t the right fit, reach out to our support team for a return authorization or setup a return by following our return instructions.
Does the Altronix AL1002ULADA come with a warranty?
Absolutely. The Altronix AL1002ULADA is backed by a manufacturer’s warranty. For full warranty terms, check the product documentation or Contact Us.
How do I get technical support or installation help for the Altronix AL1002ULADA?
You can call, text, or email our expert support team for fast answers. We’re here to help with product selection, installation tips, and troubleshooting. Contact Us
Why buy the Altronix AL1002ULADA from ZenSupply?
ZenSupply makes it easy to get the commercial door hardware you need—fast shipping, expert support, and rewards on every order. Our team is always ready to help you choose the right product for your project.
!