Altronix VERTILINE33TD DC CCTV Rack Mount Power Supply, 115VAC 60Hz at 3A Input, 16 PTC Protected Outputs 12VDC at 16A Max Total

The VERTILINE33TD runs off standard 120V building power, so it drops into a normal rack circuit without a transformer or a dedicated service. Plan the rack position near an outlet or a rack-mounted PDU on that circuit.

Yes, for a single opening it is. The VERTILINE33TD is a multi-output rack-mount unit meant to feed a whole head end. For one door, a small boxed supply makes more sense: the Securitron AQD1 is a 12/24 VDC 1 amp switching supply, the SDC 620 Series is a 1 amp regulated and filtered low voltage supply with dual voltage selection, and the Command Access PS1 is a 24VDC linear supply with 1 amp output.

Motorized latch retraction pulls a heavy inrush current and is normally fed from a supply built for it, not from a general camera or access power rack. For MLR openings, use a purpose-built unit such as the BEST RPSMLR2 Series power supply for motorized latch retraction exit devices. Delayed egress devices have their own supply as well, the BEST PS161-6, 120V input with 12/24V output at 6A.

For a one or two device load, a single-output supply is the usual choice. The Securitron AQS1210 is a switching power supply rated 12 VDC at 10 amps, and the Securitron AQL4 is a switching supply with 12/24 VDC at 4/3 amps. If the draw is very small, the ROFU 9126T is a plug-in mini power supply at 12 VDC / 1.5 A with time delay. None of these break the load into sixteen individually protected camera runs the way the VERTILINE33TD does, so you would be home-running a single pair rather than distributing.

Yes. The RCI DKPS-2A is a multi-output supply with 8 outputs at 12/24 VDC and 2 amps total for access control systems, and the BEST PS161-6 takes a 120V input and provides 12/24V output at 6 amp capacity. Both distribute to multiple devices, but at half the output count or less and with dual-voltage selection rather than the dedicated 12 VDC camera bus arrangement of the VERTILINE33TD.

Go to a field-selectable or 24 VDC unit. The Von Duprin PS902 is a Grade 1 base power supply at 2 A, 12/24 VDC field selectable for access control. The SDC 634 is a 4 amp regulated and filtered low voltage supply with dual voltage selection, and the Command Access PS1 is a 24 VDC linear supply with 1 amp output. The VERTILINE33TD is specified on a 120V input, so the difference is on the output side, not the feed.

A few items in the same family serve a different purpose. The BEST RPSMLR2 is a power supply built for motorized latch retraction exit devices and the BEST ELR150 is a power supply control module for electronic access control, so both are tied to door hardware rather than general DC distribution. The ROFU 10305-LA is a power transfer hinge rated 1.5 A at 42V, which moves power through the door rather than generating it. The Command Access CAT Field Tester is a portable 12-24VDC supply that runs off DeWalt, Makita and Milwaukee batteries and is a bench and field test tool. The VERTILINE33TD is a rack mount DC supply for camera and general low voltage loads on a 120V feed.

It is a commercial-duty unit, used as an access power controller with power supply in electronic access control and camera systems. That is the class of gear you would spec for an office building, school, or multi-family security room rather than a house.

Two multi-output alternatives we carry: the RCI DKPS-2A gives 8 outputs at 12/24VDC, 2A, for access control systems, and the Adams Rite PS-1 is a 1 amp 12/24 volt DC regulated supply with battery backup. The Command Access PS204/204B is a 2A 24VDC linear supply with battery backup if standby power is the priority over output count.

Not a direct swap. The Von Duprin PS902 is a 2A base power supply with field selectable 12/24 VDC, built to take Von Duprin option boards for door control. The Altronix is a rack-mount multi-output unit for distributing DC to many devices, so if your existing cabinet uses PS902 option boards, stay with that platform; if you are simply feeding a bank of cameras or readers from one rack position, the Altronix is the right shape.

It is a rack-mount chassis, so it takes a position in a standard equipment rack alongside the recorder and switch rather than hanging on the wall in a boxed enclosure. If you need a wall-mount box instead, look at a boxed unit like the Securitron AQS1210, a 12 VDC 10 amp switching supply.

If standby power is a requirement, look at units that state it. The Adams Rite PS-1 is a regulated 1 amp 12/24 VDC supply with battery backup, the Command Access PS204/204B is a linear supply with 2 A at 24 VDC and battery backup, and the Detex 10-800 is a universal logic controller with a 120VAC/24VDC power supply and battery backup. For an off-grid or standby-by-other-means installation, the Securitron BPSS is a boxed solar power supply.

The Aiphone AC-PS1250 is a UL listed 12V DC 5A supply for AC Series access control kits, and the ROFU 9102-12D UL / 9102-24D runs on a 10/120VAC 60Hz input. The Command Access PS210 is a UL 6E/CSA linear supply with 1.5 A at 24 VDC and boost circuitry. Those are single-device or kit-matched units; the VERTILINE33TD is the rack mount choice when you are feeding many 12 VDC camera runs from one 120V circuit.

The SDC units are single-circuit regulated and filtered low voltage supplies with dual voltage selection, stepped by output: the 620 at 1 amp, the 631 at 1.5 amp as a DC power controller, and the 632 at 2 amp. You pick one per door or per small load. The VERTILINE33TD is a rack mount DC supply that distributes 12 VDC across many PTC protected outputs from a 120V feed, so it is the choice when the head end is a rack and the loads are numerous.

A small dedicated unit is simpler for one opening. The ROFU 9126T is a plug-in mini power supply at 12 VDC / 1.5 A with a time delay built in, and the Securitron AQD1 is a switching power supply at 12/24 VDC, 1 amp. Both serve one device; the VERTILINE33TD is built to feed many circuits from a rack position.

They are aimed at different loads. The Locknetics LP Series is a 150 and 250 amp power supply supplied with an enclosure, sized for electromagnetic lock loads rated in those terms. The VERTILINE33TD is a rack mount DC supply distributing 12 VDC over multiple PTC protected outputs. Choose by what you are feeding: magnetic locks at the LP ratings, or a bank of cameras and low voltage devices from a rack.