Aiphone IPW-10VC Rack Mount 2-Wire Network Adaptor Kit

That is exactly what the IPW-10VC kit is for. It converts analog 2-conductor copper runs into an IP path, so existing 2-wire intercom cable already in the walls can carry IX and IXG stations without pulling new Cat cable. One IPW-1VT transmitter module goes at each station end, and the rack-mounted IPW-10VR receiver terminates them at the head end.

The kit ships with one IPW-10VR rack-mount receiver module and ten IPW-1VT transmitter modules. Since each station needs its own transmitter, the kit covers ten stations out of a single rack-mounted receiver.

No. The adaptor kit supplies PoE to the stations over the 2-wire run, so there is no local power supply or outlet needed at each door or room station.

Yes, the IPW-10VC works with all IX and IXG devices, so it can be used in either the IX commercial intercom system or the IXG multi-tenant system.

Yes. The IPW-10VR receiver module is a rack-mount unit, so it lands in the IT or comms rack alongside the switch feeding the IX or IXG system. The ten IPW-1VT transmitters are the field-side pieces that sit out at the stations.

The IPW-10VC is built around a ten-station count: one rack receiver plus ten transmitter modules. For a single station or a small pair of doors you are paying for eight or nine transmitters you won't install, so look at a smaller Aiphone IPW converter configuration instead. The ten-pack makes sense when you are converting a full riser or a floor of legacy 2-wire stations at once.

The modules carry LED status indicators, so you can check the link at the transmitter and at the rack-mount receiver before chasing the cable run. That narrows a fault to the 2-wire pair, the module, or the station itself.

It is a commercial-rated product, aimed at retrofitting existing 2-wire intercom infrastructure in buildings such as multi-family, schools, and healthcare facilities where an IX or IXG IP system is replacing legacy analog stations.