You may also like
Anchors 3/4 x 10 Wdg St-zn (Box 10)
Manufacturer Resources
Product Specs
- Division:
- Electrical H1
- Pack Type:
- Box
- Product Group:
- Fasteners
- Sub Division:
- Electrical-E H2
- Department:
- Electrical
- Product Subgroup:
- Anchors
Metallics TS610 – Frequently Asked Questions
1) What size hole do I drill for the Metallics TS610 wedge anchor?
The TS610 is a 3/4 inch diameter wedge anchor, so it goes into a 3/4 inch hole drilled with a carbide bit. Wedge anchors are matched one to one with bit diameter, so the hole does not get oversized. Drill deeper than the embedment you need so cuttings have somewhere to go, clean the hole, then drive the anchor through the fixture until the threaded stud projects enough for your washer and nut.
2) Is the Metallics TS610 anchor for concrete or can I use it in block and brick?
Wedge anchors like the 3/4 x 10 TS610 are for solid, poured concrete. The expansion clip needs continuous solid material to bite against, so hollow block, brick with voids, and mortar joints are the wrong base material. For hollow masonry, use a sleeve anchor or a screen tube with threaded rod instead.
3) How many anchors come in a box of Metallics TS610?
Ten anchors per box. The TS610 is packaged as a box quantity of 10 of the 3/4 x 10 zinc plated wedge anchors, so a run of equipment pads or strut bases that needs four anchors per base covers two bases with one box plus two spares.
4) Can I use the Metallics TS610 zinc plated anchor outdoors or in a wet area?
It is zinc plated carbon steel, which is a mild corrosion coating meant for dry interior work: machine bases, transformer and switchgear pads inside a building, strut and rack anchoring. Exposed exterior, washdown, pool, or coastal work will eat through zinc plating, and there stainless or hot dip galvanized anchors are the right call.
5) Is the Metallics TS610 a threaded stud anchor I can remove later?
No, it is not removable. A wedge anchor expands a clip permanently against the hole wall; backing the nut off frees the fixture but the anchor body stays in the concrete. You can cut the stud flush and patch. If the installation has to come apart and be reused, a drop-in anchor with a removable bolt is the type to specify instead.
6) What is the manufacturer part number for the Metallics 3/4 x 10 wedge anchor?
Order it as Metallics TS610. That number covers the 3/4 inch by 10 inch zinc plated steel wedge anchor supplied in boxes of ten.
How fast can I get the Metallics TS610 delivered?
Most orders ship the same day from our distribution partners, with quick delivery throughout the
continental
U.S.
Need it urgently? Contact Us for expedited shipping options.
Can I return it if it doesn’t work for me?
Yes—ZenSupply offers a hassle-free return policy. If the product isn’t the right fit,
reach out to our support team for a return authorization or setup a return by following our return instructions.
Does the Metallics TS610 come with a warranty?
Absolutely. The Metallics TS610 is backed by a manufacturer’s warranty.
For full warranty terms, check the product documentation or Contact Us.
How do I get technical support or installation help for the Metallics TS610?
You can call, text, or email our expert support team for fast answers. We’re here to help with
product
selection,
installation tips, and troubleshooting. Contact Us
Why buy the Metallics TS610 from ZenSupply?
ZenSupply makes it easy to get the commercial door hardware you need—fast shipping, expert support,
and
rewards on
every order.
Our team is always ready to help you choose the right product for your project.