Metallics J7562 Anchors 3/4 X 6-1/4 Slv Ancr &Nt St-zn (Jar 5)

Yes, that is the normal use for this anchor. The 3/4 inch body with a 6-1/4 inch length gives deep embedment for heavier loads such as strut channel, trapeze supports, transformer or panel mounting feet, and machine bases. Because the sleeve expands against the sides of the hole, it works in solid concrete and also in hollow or soft base material like block, where a wedge anchor would not hold as well.

Five pieces per jar. Each one is a 3/4 x 6-1/4 inch sleeve anchor supplied with its nut, so there is no separate hardware to order for the five fastenings.

The J7562 is zinc plated steel. That plating handles normal interior and sheltered exterior service, but it is not stainless, so in constant wet, coastal or chemically aggressive conditions it will corrode over time. For submerged or marine work, specify a stainless anchor instead.

Length is driven by the thickness of the part you are fastening plus the embedment the concrete needs. At 6-1/4 inches, the J7562 is sized for thick base plates, shims, or stacked material where a short anchor would bottom out before it grips. If you are fastening thin strut or a clamp directly to a slab, a shorter 3/4 inch sleeve anchor gets you the same hold with less drilling, since embedment is what carries the load.

Metallics catalogs it as J7562. That number covers the 3/4 inch diameter by 6-1/4 inch zinc plated steel sleeve anchor supplied with nut, five to a jar.