B-Line Eaton series hanging system, KwikPak wire rope and clamps kwikpak, Kwik-clamps and spool of wire rope included, 1/16" wire max

The KwikPak kit is built around 1/16 inch wire rope, and the Kwik-clamps in it are rated to a .062 inch maximum wire diameter. The rope itself is listed at .06 inch diameter. If you are hanging off anything heavier than 1/16 inch cable, these clamps are the wrong grip size.

Both are in the pack. The BKP10063 KwikPak ships as a spool of wire rope plus Kwik-clamps, so you are not sourcing grippers on a separate line. Anchors into the deck or structure and whatever attaches to the fixture end are not part of the kit.

No. The Kwik-clamps top out at .062 inch wire, which is 1/16 inch, so 3/32 cable will not seat in them. Either use the 1/16 inch rope supplied in the pack, or move up to a clamp rated for the larger diameter cable you already have.

Cable is the faster choice for suspending fixtures, signage, or light runs from an open deck: you shoot one anchor, drop the rope, and set the grip at final height instead of cutting and coupling rod. Threaded rod is what you want where the load has to be held rigid against sway or where the support has to resist upward and lateral force, since a cable only works in tension. The KwikPak is the cable side of that decision, with clamps sized to 1/16 inch rope.

The pack is a bulk spool rather than a fixed count of pre-cut drops, so the number of hangers depends on the drop height you cut to. The spool is listed at 500 inches and the whole pack weighs 12.85 lb, so plan your cuts off your ceiling-to-fixture dimension plus tail for the clamp.

Order it as BKP10063, an Eaton B-Line series part. The model is catalogued as KwikPak wire rope and KwikPak clamps, which is the combined rope-and-grip pack rather than clamps on their own.