B-Line Eaton series hanging system, KwikWire wire rope, Y Toggle termination, 63" wire length, 30" leg

Total wire length is 63 inches, with a 30 inch leg on the Y. Plan the drop around that 63 inch overall figure, less whatever you take up at the toggle and at the Y split. If your ceiling-to-fixture distance is longer than that, you need a longer wire length in the KwikWire range rather than this one.

It carries a cULus Listing, which covers it for both US and Canadian installations. That is the item inspectors look for on suspension hardware in commercial and institutional work.

The Eaton B-Line KwikWire BKYT30-063 is a wire rope hanging kit with a Y toggle termination, used to suspend electrical and lighting loads from a structure above. The Y configuration splits into two legs so a single overhead attachment point can carry a fixture or run that needs two pickup points, with the toggle end anchoring into the deck or slab. It is cULus Listed.

The toggle termination is the anchor end: it is made to pass through a drilled hole in the deck or slab and toggle open behind it. No add-on anchor is needed for that end. Confirm your overhead substrate suits a toggle rather than a beam clamp or eye lag, because those applications call for a different KwikWire termination style.

Use the Y version when the load needs two pickup points but you only have one good overhead anchor, which is common on linear fixtures, cable tray, and light strip runs. A single straight-leg hanger is the simpler choice when each fixture point gets its own anchor above it. This kit is the Y type with a 30 inch leg off a 63 inch total wire length.

Each kit weighs .976 lb, so a carton of them is easy to carry up a lift. Useful when you are figuring shipping on a bulk order for a large lighting package.