B-Line Eaton series open racks, Aluminum, Mounting units: 6, Telco gray powder coat, Wall mounted patch panel bracket 19" or 23" panel mount, hinged

Yes. The Eaton B-Line SB750190606TG hinged wall bracket is drilled for either 19 inch or 23 inch panel mounting, so the same bracket handles standard 19 inch rack-mount patch panels and the wider 23 inch telco panels. You pick the hole pattern you need at install.

Six mounting units (6U) of usable panel space. That is enough for a couple of 48-port patch panels plus a wire manager, or a small switch and panel combination in a closet where a floor rack will not fit.

It measures 19 inches wide, 10.5 inches high and 6 inches deep, and weighs 12 lb empty. The 6 inch depth is the thing to check first: it suits patch panels, wire managers and shallow gear, not full-depth switches or servers.

The bracket swings out from the wall, so you can get behind the patch panel to terminate, re-punch or trace cable without dismounting anything. On a fixed bracket you either leave working clearance on the sides or pull the panel off the wall to reach the rear. That matters most in a tight IDF or a shallow closet.

Go with the open hinged bracket when you need airflow, fast rear access and low cost, and the equipment does not need to be locked up. A wall cabinet is the better call when the gear has to be secured against tampering, kept clean in a dusty space, or when you need doors for appearance in a finished area. This bracket is open frame, 6U, 6 inches deep, so it is aimed at cross-connect and patching rather than housing active equipment.

The frame is aluminum with a Telco gray powder coat finish. Aluminum does not rust the way bare or painted steel does, which is why it is a reasonable choice for a mechanical space or a garage-level telecom closet. The gray powder coat matches typical telco rack and cabinet finishes.

Wall anchors are a field call: the fasteners depend on whether you are hitting wood studs, steel studs, concrete or plywood backing, so size them to the substrate and to the 12 lb bracket plus your panel and cable load. You will also need your own rack screws or cage nuts to hang the patch panels, since those ship with the panels rather than the bracket.

SB750190606TG is the full manufacturer part number for the 6U aluminum hinged wall bracket in Telco gray. It is a single configuration, not a family of sizes, so if you need more than six mounting units you are looking at a different part in the B-Line series rather than an option on this one.