B-Line Eaton series open racks, Steel, #12-24 mounting hardware, Three mounting spaces required, Flat black powder coat, CPU/Monitor rack mounted sh

Three mounting spaces are required for the SB741V19SFB shelf, so plan on 3U of open frame rack height. At 5.19 inches high it matches that 3U allowance, and you need three clear hole groups on both front rails before anything below or above it is mounted.

Yes. The SB741V19SFB is part of the Eaton B-Line series open frame rack line and mounts to the front rails of a standard 19 inch open rack using #12-24 hardware. Overall width is 17.31 inches, which sits inside the rails, with the mounting flanges spanning the 19 inch EIA opening.

It is built for #12-24 mounting hardware, the thread used on B-Line series open frame rack rails. If your rack is tapped for 10-32 or uses square-hole cage nuts, you will need the correct hardware for that rail rather than #12-24 screws.

Depth is 15 inches, measured front to back, with a 17.31 inch width and 5.19 inch height. On a two-post open frame rack the shelf cantilevers off the front rails, so check that 15 inches of projection clears anything mounted behind it and that your monitor base or small form factor CPU footprint fits within that depth.

A shelf like the SB741V19SFB is the simpler choice when you already have a monitor and keyboard and only need somewhere in the rack to set them, and it gives you an open ventilated platform for a CPU at the same time. A sliding console drawer or KVM drawer integrates the screen and keyboard into one 1U unit and takes less rack height, but it costs you the CPU surface and you cannot swap the display. This shelf needs three mounting spaces, so budget the height before choosing it.

The SB741V19SFB is a CPU/monitor shelf with a keyboard extension, so it gives you one rack mounted work surface for a monitor or small PC plus a pull-out area for a keyboard. That suits an IDF or MDF closet where a technician needs a local console at the rack instead of a separate desk.

The shelf is a ventilated design, so air moves through the platform rather than being trapped under the equipment sitting on it. In an open frame rack with no doors that keeps a CPU or appliance from sitting on a solid sheet of steel.

Steel construction with a flat black powder coat, which matches the standard black finish on B-Line series open frame racks and cable management so an existing rack lineup stays consistent. Shipping weight of the shelf itself is 13 lb.