B-Line Eaton series runway support, Telco gray, Used with 3/8" X 2" stringers, 20" runway width, Cable runway center hung supports

A center hung support hangs the cable runway from overhead, typically on threaded rod dropped from the structure, so the runway floats down the middle of a room rather than being carried off a wall angle or off the tops of equipment racks. Use it where the runway route does not follow a wall and you do not want the cabling load sitting on the racks. The B-Line SB2127S202TG is that overhead type, for 20 inch runway on 3/8 x 2 inch stringers.

The support measures 7.625 inches in height, 21 inches in length/depth and 20 inches in width. Allow for that 7-5/8 inch height plus your threaded rod and hardware when you set the runway elevation under ductwork, sprinkler lines or a low deck.

No. The SB2127S202TG is the support itself, for 20 inch runway on 3/8 x 2 inch stringers. Threaded rod, overhead attachment (beam clamps or concrete anchors), rod couplings and the runway sections themselves are ordered separately.

Telco gray is the standard finish on this support, which is the same gray used across B-Line cable runway and ladder rack, so it blends with existing runway, wall angles and racks in a typical telecom or MDF room rather than standing out.

Each support weighs 4.3 lb. Add that to the runway stringer weight and the cable fill when you size threaded rod, concrete anchors or beam clamps at each hanger point.