Cahaba CA325050UMLDB-18 32 in. Standard Radius 18 Ga. 50/50 Low Divide Double Bowl Undermount Stainless Steel Kitchen Sink

No. Mounting hardware is not included with this undermount sink, so order undermount clips, studs or brackets separately, or have your fabricator supply them with the countertop. A bottom basin rack (grid) is included.

Budget for two basket strainers or a strainer plus a disposal flange, tailpieces and a continuous waste tee for the two rear drains, undermount clips or brackets, and silicone. The bottom grid comes with the sink, so you don't need to buy that. Faucet and air gap or soap dispenser are separate, and the sink has no deck holes since it mounts under the counter.

The divider between the two 14-9/16 inch bowls sits below the rim rather than running full height, so a sheet pan or a long-handled pot can lay across both sides while you still get two separate drains. It is the middle ground between a full single bowl and a conventional 50/50.

Both drains are set to the rear of the bowls. That keeps the P-traps and tailpieces toward the back wall, which frees up usable storage space under the cabinet for a pull-out or a disposal.

It is built as an undermount, which means it mounts beneath the deck and relies on a finished, sealed cutout edge. That suits stone, quartz and solid surface. Standard laminate tops are not a suitable substrate for undermounting unless the fabricator supplies a purpose-made laminate undermount edge treatment; otherwise choose a drop-in sink instead.

Yes, standard disposals mount to either bowl. With a 9 inch bowl depth plus the disposal body, check your cabinet interior height and the location of the drain stub-out; the rear drain position gives more room to angle the discharge into the trap.

Standard radius, not zero radius. The bowls are rectangular with softly curved corners, which takes a sponge more easily than a tight zero-radius corner while still reading modern under the counter.