You may also like
Camden CM-TX-9 Lazerpoint RF 915 MHz Wireless Transmitter for Wall Mounted Button/Switch with Alkaline Batteries
Model: CM-CM-TX-9
Camden CM-TX-9 Lazerpoint RF 915 MHz Wireless Wall-Mount TransmitterThe Camden CM-TX-9 is a 915 MHz wireless transmitter designed for wall-mounted button and switch applications within the Lazerpoint...
Camden Door Controls
$84.00
$46.28
Camden CM-RX91 Wireless Single Relay Receiver – 915 MHz Lazerpoint RF, 12–24 V, Push-and-Learn Setup
Model: CM-CM-RX91
Camden CM-RX91 Wireless Single Relay Receiver – 915 MHz Lazerpoint RF, 12–24 V, Push-and-Learn Setup
The Camden CM-RX91 is a high-performance single-relay
Camden Door Controls
$105.00
$98.00
Camden CM-TXLF Series 915 MHz Wireless Key Fob Transmitters – 1-Button Lazerpoint™ RF (Raised or Recessed Button Options)
Model: CM-CM-TXLF-1
Camden CM-TXLF Series 915 MHz Wireless Key Fob Transmitters – 1-Button Lazerpoint™ RF (Raised or Recessed Button Options)
The Camden CM-TXLF Series offers durable and reliable
Camden Door Controls
Starting at
$63.00
$42.38
Camden SureWave CM-336 Series Wireless, Built-In 915MHZ/40 Hand Icon Faceplate Touchless Switch
Model: CM-336-40
SureWave CM-336 Series Wireless, Built-In 915MHZ/40 Hand Icon Faceplate Touchless Switch
CM-336 touchless switches offer the longest battery life, up to 100 activations day for 4 years, with an...
Camden Door Controls
Starting at
$250.00
$226.85
CAMDEN LAZERPOINT RF 915MHZ. WIRELESS DOOR CONTROL SYSTEM
Lazerpoint RF™ is a completely new wireless solution for automatic door operators. The system introduces the many advantages of 915MHz. spread spectrum wireless technology to the automatic door market. The system encompasses the widest range of transmitters, receivers, activation devices and switch enclosures available today. Lazerpoint RF™ receivers also supports 300MHz., 390MHz., and 433MHz. transmitters, with the use of optional daughterboards.
Kit Inclusions
- CM-RFL254-A - (2) CM-25/4 WHEELCHAIR & ‘PUSH TO OPEN‘, (2) CM-23D Surface Boxes, (2) CM-TX-9 Transmitters, (1) CM-RX-90 Receiver
- CM-RFL404-47-A - (2) CM-40/4 WHEELCHAIR & ‘PUSH TO OPEN‘, (2) CM-47S Surface Boxes, (2) CM-TX-9 Transmitters, (1) CM-RX-90 Receiver
- CM-RFL454-SA - (2) CM-45/4 WHEELCHAIR & ‘PUSH TO OPEN‘, (2) CM-43CB Surface Boxes, (2) CM-TX-9 Transmitters, (1) CM-RX-90 Receiver
- CM-RFL464-LPA - (2) CM-46/4 WHEELCHAIR & PUSH TO OPEN, (2) CM-43LP Surface Boxes, (2) CM-TX-9 Transmitters, (1) CM-RX-90 Receiver
- CM-RFL604-69-A - (2) CM-60/4 WHEELCHAIR & ‘PUSH TO OPEN‘, (2) CM-69S Surface Boxes, (2) CM-TX-9 Transmitters,(1) CM-RX-90 Receiver
Specifications
| Wireless Frequency: | 905.25 / 915.25 / 925.25 MHz. Spread Spectrum |
| Wireless Range: | |
| CM-TX-9,CM-TX-99: | 500ft (152m) open area |
| CM-TXLF Series: | 250ft (76m) open area |
| Receiver Capacity: | 40 CM-TX Series Transmitters |
| Codes: | 1 Million Unique (20 Bit) Codes |
| Power/Voltage: | |
| Receivers: | 12/24 V, AC/DC |
| CM-TX-9: | (2) AAA alkaline batteries (supplied)
(2) AAA Lithium batteries (option) |
| CM-TX-99: | Plug-in, power by device |
| CM-TXLF Series: | CR2032 Lithium battery |
| Battery Life: | |
| CM-TX-9: | 500,000 cycles |
| CM-TXLF Series: | 115,000 cycles |
| Status & Alarm Indicators: | |
| CM-TX-9,CM-TXLF Series: | Transmission confirmation, low battery, battery test & stuck switch |
| Receivers: | Relay status, signal strength, erase mode & pot position |
| Output: | |
| CM-RX-90: | (1) SPDT relay, 3 modes |
| CM-RX-91: | (1) SPDT relay, 1 mode |
| CM-RX-92: | (2) SPDT relays, 6 modes |
| Contact Rating: | 3 Amps @ 30VDC |
| Current Draw: | |
| CM-TX-9: | 2 mA |
| CM-RX-90: | 23mA - 43mA |
| Time Delay: | |
| CM-RX-90,CM-RX-91: | 1-30 seconds |
| CM-RX-92: | #1 D.O.R. 1-30 sec.
#2 D.O.O. 1-15 sec. #2 D.O.R. 1-30 sec. |
| Temp Range: | Alkaline: 32°F to 122°F (0°C to 50°C)
Lithium: -40°F to 122°F (-40°C to 50°C) |
Manufacturer Resources
Product Specs
- Relay Action:
- Multi Function
- Warranty:
- 3 Year Limited
- Wireless Communication:
- Yes
- Subcategory:
- Wireless Door Control System
- Number of Relays:
- 1
- Batteries:
- AAA (2)
- Battery Operated:
- Yes
- Commercial/Residential:
- Commercial
- Product Type:
- Wireless Door Control System
- Power:
- Battery Operated
- Product Group:
- Electronic Access Controls
- Product Subgroup:
- Wireless Door Control System
- Product Voltage:
- 12VAC/DC/24VDC/24VAC
- Fire Rating:
- No
- Switch Device:
- SPDT
- Product Category:
- Electronic Access Control
- Product Weight:
- 3.1
- Department:
- Door Hardware
Camden Door Controls CM-RFL454-SA – Frequently Asked Questions
1) What comes in a Camden Lazerpoint RF wireless door control kit?
Each Lazerpoint RF kit ships as a complete two-station package: two wheelchair symbol / 'PUSH TO OPEN' actuator switches, two matching surface boxes, two CM-TX-9 transmitters and one CM-RX-90 receiver. So you get an interior and exterior push station plus the receiver that drives the operator. What differs between kits is the switch style and its box, for example CM-RFL254-A pairs CM-25/4 switches with CM-23D boxes, while CM-RFL604-69-A pairs CM-60/4 switches with CM-69S boxes.
2) Which Camden push plate size should I pick for a narrow aluminum storefront stile?
Go with the CM-25 narrow stile switch. The 4-1/2 inch round CM-40, the 4-1/2 inch square CM-45 and CM-46, and the 6 inch round CM-60 all need a wider mounting face than a typical storefront stile gives you. Pick the round or square plates for wall mounting beside the opening, and the CM-25 for the door stile or jamb itself.
3) How far can the Camden wireless push plate be from the receiver?
The CM-TX-9 transmitter supplied in these kits is rated 500 ft (152 m) in open area. Camden's smaller CM-TXLF series transmitters are rated 250 ft (76 m). Those are open-area figures, so metal doors, block walls and elevator shafts between the plate and the receiver will cut into it. For a normal vestibule or lobby where the push plates sit within a few dozen feet of the operator, range is not the limiting factor.
4) Do I have to run wire to the push plates for a Camden Lazerpoint RF system?
No wire to the push stations. The CM-TX-9 transmitters run on two AAA alkaline batteries, which are supplied, so the actuators mount anywhere without conduit. The only wiring is at the receiver end: the CM-RX-90 takes 12/24 V AC or DC and its relay lands on the operator's activation input. That is what makes this practical for retrofits into finished terrazzo, block, or glass front vestibules where fishing wire to a push plate is not realistic.
5) Will the Camden CM-RX-90 receiver relay drive my automatic door operator?
The CM-RX-90 gives you one SPDT relay rated 3 amps at 30 VDC, with three operating modes and an adjustable time delay from 1 to 30 seconds. That is a dry contact, so it wires into the operator's activation terminals the same way a hardwired push plate would. Check the operator input is a dry contact closure and stays within 3 A at 30 VDC and it will work.
6) Will a Camden wireless push plate work on an unheated exterior entrance in winter?
Only if you change the batteries. With the supplied AAA alkaline cells the operating range is 32F to 122F (0C to 50C), which is not enough for an exposed exterior actuator in a cold climate. Camden offers AAA lithium batteries as an option for the CM-TX-9, and those extend the range to -40F to 122F (-40C to 50C). Spec the lithium option for anything outside a conditioned vestibule.
7) What is the difference between the Camden CM-45 and CM-46 push plates?
Both are 4-1/2 inch square actuators; the difference is fastening. The CM-45 uses concealed screws for a cleaner face in public lobbies and areas where tampering is a concern, and the CM-46 uses exposed screws, which is quicker to service. They also ship with different surface boxes, CM-43CB with the CM-45 and CM-43LP with the CM-46.
8) Can I add more push plates later to one Camden receiver?
Yes. A Lazerpoint RF receiver holds up to 40 CM-TX series transmitters, so the two transmitters in the kit leave plenty of room to add stations later, for instance a third actuator at a side entrance or an interior wheelchair plate on a second vestibule door. Each transmitter carries one of 1 million unique 20-bit codes, so neighboring systems in the same building will not cross-trigger.
9) Can I use a Camden Lazerpoint RF receiver with my existing 300MHz or 433MHz transmitters?
Yes, with optional daughterboards. The Lazerpoint RF receiver runs 915MHz spread spectrum natively (905.25 / 915.25 / 925.25 MHz) and will also accept 300MHz, 390MHz and 433MHz transmitters when the matching daughterboard is added. That matters on a site where older Camden actuators are already in place and you only want to swap the head end.
10) How often will maintenance have to change batteries in these wireless door actuators?
The CM-TX-9 transmitter is rated for 500,000 cycles on its batteries, so on a normal entrance it is a long interval, not a monthly task. The transmitter also signals low battery and offers a battery test, and the plate confirms transmission, so staff get warning rather than a dead door. Camden's smaller CM-TXLF series transmitters, which run a CR2032, are rated 115,000 cycles by comparison.
11) I need two relays or a plug-in transmitter instead of battery, does Camden make those?
Yes, within the same Lazerpoint RF family. If one relay is not enough, the CM-RX-92 receiver carries two SPDT relays with six modes and separate timing (door open relay 1 to 30 seconds, door open output 1 to 15 seconds), which suits sequencing a vestibule pair or firing an operator and an electric strike together. The CM-RX-91 is the simpler single relay, single mode version. If you would rather not maintain batteries at the actuator, the CM-TX-99 transmitter is plug-in and powered by the device it mounts in.
12) Are these Camden actuators suitable for a commercial or institutional building, and are they fire rated?
Lazerpoint RF is a commercial-grade product, intended for automatic door operator activation in commercial and institutional entrances. It is not fire rated, so it is an activation device rather than anything that contributes to the rating of a fire door assembly. The blue wheelchair symbol and 'PUSH TO OPEN' faceplate is the standard barrier-free actuator graphic used at accessible entrances.
How fast can I get the Camden Door Controls CM-RFL454-SA delivered?
Most orders ship the same day from our distribution partners, with quick delivery throughout the
continental
U.S.
Need it urgently? Contact Us for expedited shipping options.
Can I return it if it doesn’t work for me?
Yes—ZenSupply offers a hassle-free return policy. If the product isn’t the right fit,
reach out to our support team for a return authorization or setup a return by following our return instructions.
Does the Camden Door Controls CM-RFL454-SA come with a warranty?
Absolutely. The Camden Door Controls CM-RFL454-SA is backed by a manufacturer’s warranty.
For full warranty terms, check the product documentation or Contact Us.
How do I get technical support or installation help for the Camden Door Controls CM-RFL454-SA?
You can call, text, or email our expert support team for fast answers. We’re here to help with
product
selection,
installation tips, and troubleshooting. Contact Us
Why buy the Camden Door Controls CM-RFL454-SA from ZenSupply?
ZenSupply makes it easy to get the commercial door hardware you need—fast shipping, expert support,
and
rewards on
every order.
Our team is always ready to help you choose the right product for your project.