OATEY 2651-1 Dearborn® 1-1/2" J-Bend - Budget Ga.

Yes, for a 1-1/2 inch tubular drain line. The Dearborn 2651-1 is a 1-1/2 inch J-bend with slip joint ends, which is the standard tubular size for kitchen sink and most residential waste arms. Slip joint ends mean it seals with a washer and nut rather than threading or gluing, so it drops into an existing 1-1/2 inch tubular trap assembly.

A J-bend is only the U-shaped half of the trap. To make a complete P-trap you also need a trap arm (the horizontal piece running to the wall) plus slip joint nuts and washers at each connection, and a tailpiece from the sink drain down to the bend. Buyers replacing a leaking trap often only need the bend, but confirm what you are pulling out before ordering just the 2651-1.

That is what it is built for. The 2651-1 is brass with a chrome plated finish, so it is meant to be seen under a wall-hung lavatory or open-base vanity rather than hidden behind a cabinet door. If the trap is concealed, a plastic tubular J-bend does the same job for less.

No. It is a drainage fitting rated to a maximum working pressure of 15 psi, far below any potable supply pressure. Use it only on gravity waste piping under a sink or lavatory.

Order it as Oatey/Dearborn 2651-1. It weighs 0.45, which is light enough that property managers and maintenance shops commonly stock several for turnover and callback work.