Deltana PW350 Wire Pull, 3-1/2"

The 3-1/2 inch figure on the PW350 is the pull's length. Deltana publishes it as the size of the pull itself, not as a hole spacing, so if you are matching an existing drilled cabinet door you should measure your hole centers before ordering. For a pull specified by hole spacing, Trimco's 562 Series drawer pulls are listed in 3-1/2 inch, 4 inch, and 96mm center-to-center options.

The Trimco 562 Series drawer pull is offered in 3-1/2 inch, 4 inch, and 96mm center-to-center options, so the 3-1/2 inch 562 covers the same size as the Deltana PW350, which is a 3-1/2 inch solid brass wire pull. The PW350 is a wire-form bail pull; the 562 is a Trimco drawer pull series, so confirm the profile suits the door or drawer face before swapping.

Nine finishes: PVD Polished Brass, Polished Brass, Antique Brass, Oil Rubbed Bronze, Brushed Nickel, Antique Nickel, Polished Chrome, Brushed Chrome, and Paint Black. If you are standardizing a whole kitchen or an apartment turn, the PVD Polished Brass is the one to look at where hands and cleaners are constantly on the hardware, since PVD is a harder coating than standard lacquered brass plating.

Deltana classifies the PW350 as residential. It is used on both residential and commercial cabinetry, but it carries no commercial grade rating, so for a high-traffic institutional millwork spec you would normally look at a heavier bar pull instead, such as the Orca Hardware CK-12001 T-pull bar in steel.

Each. The unit of measure is one pull, and the price shown is per pull, so a 20-door kitchen needs 20 line quantity, not 10 pairs.

A wire pull like the PW350 is a slim solid brass bow. If you want more mass and a stated projection, the Omnia 1969 and 1971 modern pulls are forged solid brass with 1-3/16 inch projection, the Omnia 1970 with 1-1/4 inch projection, and the Omnia 1968/102 in forged solid brass at 4 inch center-to-center. Those are the ones to compare when knuckle clearance behind the pull is the deciding factor.

No, a surface-mounted wire pull always projects off the face. For a flush condition, use an edge pull instead: the Schaub Sabre edge pulls come in 3 inch, 4 inch, and 5 inch center-to-center in solid brass, and they mount at the door edge with nothing protruding into the aisle.

Yes. It is a pull-type handle used on cabinet doors and drawer fronts alike. At 3-1/2 inches long it suits standard door stiles and narrower drawer fronts; for wide drawers or an appliance front you want something longer, like the Schaub 79-8 Steamworks 8 inch pull.

The PW350 is a plain wire-form pull in solid brass. For styled profiles, Emtek's Schaub Collection cabinet pulls include the Art Deco and Alexander series, and the Emtek Bar cabinet pull for a straight bar look. All are cabinet knob/pull products, so they serve the same function as the PW350 with a different design vocabulary.