B-Line Eaton series Grip Strut ten diamond plank, 120" Grating length, 24" Grating width, Steel, 3" Channel size, Plain, 12 gauge

Yes. The Grip Strut ten diamond plank is listed as OSHA compliant and is intended for safe, sturdy footing where a non-slip surface is required. The diamond openings in the formed steel surface shed liquid, grease and debris rather than holding it, which is why it gets used on catwalks, platforms, stair treads and equipment access walkways.

Plain means bare steel with no protective coating applied. It is the right choice for dry interior use, or where you plan to paint or coat the plank yourself after install. For wet, washdown or exterior locations, specify a galvanized or coated version instead, because untreated carbon steel will corrode.

Diamond count is how you read the width. The ten diamond plank runs 24 inches across, which is a full walkway width in a single piece. Narrower sections with fewer diamonds are used for stair treads, single-file catwalks and ladder platforms where you only need a foot or so of tread. Pick by the finished walking width you need, then match the 3 inch channel depth to your support spacing.

The plank ships as the grating section only. Hold-down clips, saddle clips, bolts or weld attachment to your supporting steel are ordered separately and chosen to suit the 3 inch channel depth and the beam or angle you are landing on. Plan the support layout before ordering so you buy the right attachment count.

Yes, the formed 12 gauge steel plank can be cut on site to suit an opening, and a 120 inch piece is commonly trimmed down to a shorter platform run. Cut ends on a plain, uncoated plank should be dressed and painted, since there is no factory coating to protect the raw edge.