B-Line Eaton series ground mounted panel enclosure, 60" height, 18" length, 48" width, 4X, Hinged cover, 4XSFSD3PT enclosure, Ground mount, Large dou

The 604818-4XSFSD3PT measures 60 inches high, 48 inches wide and 18 inches deep. At 48 inches wide it will not pass through a standard 36 inch door opening upright, so plan on a loading dock, double doors, or an outdoor set. It also weighs 404.3 lb, so rigging or a forklift is the realistic way to place it.

It carries a NEMA 4X rating and is built from 304 stainless steel with a seamless poured in-place gasket, which is the combination used for outdoor, washdown and corrosive duty. The enclosure is UL 50 listed.

No. This ground mounted 60 x 48 x 18 enclosure ships with no mounting provisions inside, so the back panel, rails, DIN rail or any gear-mounting hardware has to be ordered separately and specified to suit what you are installing.

It is a ground mount design, meaning it sits on a floor or pad rather than hanging on a wall. There are no wall mounting brackets or panel provisions on it, so the usual approach is a level concrete pad or a floor stand with the base anchored down. At 404.3 lb the supporting surface needs to be rated for it.

Yes. The double door is closed by a 3-point latching handle with a key lock and padlock provision, so you can either key it or hasp a padlock through it. That is the arrangement most utilities and facilities ask for on a ground mounted outdoor cabinet.

The body is 12 gauge 304 stainless steel with a #4 brushed finish. Twelve gauge is the heavier end of enclosure construction, which is why the 60 x 48 x 18 box lands at 404.3 lb, and it is what lets a full-height double door hold its seal without racking.

On a 48 inch wide cabinet the double door is the practical choice: each leaf swings clear in roughly half the space, so you can service the gear in an aisle where a single 48 inch leaf would not open. The trade-off is the center seam, which is why this model uses a 3-point latching handle and a poured in-place gasket to hold the 4X seal across both leaves. If you have full clearance and want the simplest gasket path, a single door style is the alternative.

The box ships with no mounting provisions and no factory conduit holes, so every entry is field cut. The 4X rating only holds if each penetration uses a 4X rated hub or fitting with the proper seal; an unsealed knockout in 12 gauge 304 stainless gives you a washdown leak path straight onto the gear. Cut entries on the bottom or lower sides wherever the layout allows.