B-Line Eaton series imperial cable tray and ladder, 4" Height, 15.000" Length, 6" Width, Series 2-5 vertical outside bend, Aluminum, 90° Angle, 12" Ra

Yes. The 4A-06-90VO12 is built for a 6 inch tray width with a 4 inch side rail height, in aluminum, so it mates with a matching 6 inch wide, 4 inch deep aluminum ladder tray run. Match your straight sections on both width and rail height before ordering, since a 4 inch rail fitting will not line up with a 6 inch rail section.

A vertical outside bend carries the tray over an obstruction or up a change in elevation where the cables ride on the outside of the turn, such as a run climbing a wall or stepping over a beam. The 4A-06-90VO12 makes a 90 degree change of direction on a 12 inch radius. If your run needs to drop down and the cables follow the inside of the curve instead, you want a vertical inside bend, not this part.

Plan on 15 inches of length for the fitting itself when you lay out the run, on a 6 inch tray width and 4 inch rail height. It weighs 4.9 lb, light enough for one person to set and bolt up overhead, which is typical of aluminum tray fittings.

Aluminum is the material here, and it holds up well in damp indoor and many outdoor environments without a coating, while keeping the fitting light at 4.9 lb. In heavy chemical exposure or wash-down areas, specifiers often move to a coated or stainless tray system instead. Keep the whole run one material where you can, so you are not mixing aluminum fittings into a steel tray and creating a dissimilar metal joint.

Order Eaton B-Line part number 4A-06-90VO12. Reading the number: 4A is the 4 inch aluminum rail, 06 the 6 inch tray width, 90VO the 90 degree vertical outside bend, and 12 the 12 inch radius.

The 4A-06-90VO12 vertical outside bend is CE marked, which is the mark asked for on projects specified to European requirements.