B-Line Eaton series imperial cable tray and ladder, 6" height, 34.24" length, 42" width, Series 2-5 vertical inside bend, 30°, 48" radius, Aluminum

A vertical inside bend carries the tray run up or down a change in elevation with the fitting curving toward the inside of the angle, so the cables ride on the concave side. The Eaton B-Line 6A-42-30VI24 is the Series 2-5 vertical inside bend at a 30 degree angle on a 48 inch radius. Use the inside bend where the run rises away from the tray bottom (for example the run drops and then turns back up under an obstruction); use an outside bend where the tray bottom is on the outside of the curve. Picking the wrong one leaves you with a fitting that will not bolt up in the direction your run travels.

Order Eaton B-Line 6A-42-30VI24. Reading the number: 6 inch rail height, A for aluminum, 42 inch width, 30 degree angle, VI for vertical inside, and 24 for the radius designation on the 48 inch radius fitting. Only that one configuration is offered under this part number, so there is nothing further to specify on the order.

CSA is the certification on record for the 6A-42-30VI24 vertical inside bend, which is the mark inspectors look for on Canadian installations. That is the only listing stated for this fitting.

The 6A-42-30VI24 is supplied as the bend fitting itself. Splice plates, bolts and any hangers or supports at the elevation change are ordered separately, and they have to be the splice type matching the Series 2-5 rail so the connection lands correctly on both the straight section and the fitting.